Remove Aluminum Rivets EASY - Drill Out & Cut Off - Jon Boat Aluminum Boat Rivets
Тәжірибелік нұсқаулар және стиль
Join the community on Discord: / discord
- In this video I explain and demonstrate how to easily remove aluminum rivets from a Jon Boat / Aluminum Boat for things like removing benches or replacing your transom.
Follow me on Instagram: @MVBOutdoors
/ mvboutdoors
1648 Jon Boat Build Playlist
-- • 1648 Jon Boat Build - ...
---Product Links*------
Center Punch - amzn.to/36QhkEg
---Other Videos------
How & Where To Grease Boat Engine & Trailer | Grease Gun Tips & Tricks
-- • How & Where To Grease ...
How To Install Boat Transducer
-- • How To Install a Trans...
How To Apply Vinyl Registration Numbers
-- • HOW TO APPLY BOAT REGI...
*Orders through the Amazon affiliate links above provide us with a small referral commission at no cost to you. Using affiliate links in no way affects our opinions expressed on this channel and merely serve as a method to help this channel grow while still providing useful, relevant information. ------------
#jonboat #boating #fishing
Пікірлер: 18
Used all those methods and they each have their place. On a job like this you may use all methods depending on reach, accessibility and so on. Nice explanation
I want somehow to pop out the rivet from one side. cause its a rivet on exhaust pipe and i cant make it the other way without open the hole exhaust
Thank you for this video !!!
@mvboutdoors
2 жыл бұрын
Very welcome! Hope it's helpful.
Nice method. Im about to start, i have 12 leaking rivets on the bottom of my boat that im getting ready to replace. Thanks for the video bro!
@mvboutdoors
Жыл бұрын
Goodluck!
@c.shoefish
Жыл бұрын
@@mvboutdoors dude. It worked awesome... chiseling them off is way easier, faster and cleaner than trying to drill them. Worked like a charm.
@mvboutdoors
Жыл бұрын
@@c.shoefish Oh yeah its a super clean way of removing them. Way faster!
That was so helpful. Worked like a charm.
@mvboutdoors
Жыл бұрын
Awesome, glad it helped. For me it was one of those things I didn't understand how to do until I saw it.
Use a metal chisel and save your screwdriver. Those handles will bust and end up in your hand. Ask me how I know
@mvboutdoors
2 жыл бұрын
You're not wrong about that! Good advice, this has become my utility flat edge but I wouldn't recommend using a good driver on this.
@OttoTheWeim
Ай бұрын
Spot on. You can also just buy either a cheap cobalt screwdriver that has a hammer head on the handle or any of the good German drivers have heads like Wera.
not bad but its not advisable on aluminum screen door it wreck it if you use hammer
I’m guessing you use a drill bit for metal? 😅
@mvboutdoors
Жыл бұрын
Yes, you want it to be slightly bigger than the hole in the center of the rivet. 3/16 usually a good start.
Seth Rogen
@mvboutdoors
2 жыл бұрын
heh heh heh heh heh