I have done this before by hand with a hand drill. All i did was buy a wheel spacer with the bolt pattern i wanted and put a hub centric spacer ring to make the spacer fit perfect over the hub. Then center punched all the holes. Then drilled and tapped them. And bought wheel bolts instead of studs. Super easy. Diy

To get a flat surface on the backside, I use a counterbore with an alignment pin and just clean up the surface. Works best with a drill press.

I want to do the opposite 5x4.5 to 5x5.5 to put f150 wheels on a ranger good video

Thanks for sharing this. Been thinking about buying one. Seems to work very good. Thanks again you got my sub. Take it easy👍

I just tap the holes and use screw in studs with thread lock. Work's perfect.

@thedelawareranch2379

2 жыл бұрын

That was a thought i had at one point as well

Any video on rear

I know you got this a while back... do you remember who u bought this from?

amazing video man 🤌 this is a great video that explains it and shows it well

Where did u get that tool from

Could you just grind a small bevel on the stud seating surface where the radius on the rotor interferes with it going all the way down?

@thedelawareranch2379

Жыл бұрын

Yes it you could it just needs to have a way for the stud to sit straight with out doing something the stud will always be pulling at a angle hope that helps

Where can I buy this tool ?

I just want to know. Is that yellow drill still rocking back and forward to this day?

@thedelawareranch2379

8 ай бұрын

It sure is don’t ask how lol

Hey im in Delaware i need you to do mines!!!!

@thedelawareranch2379

29 күн бұрын

I’m down the beach

who makes the wheels?

@thedelawareranch2379

2 жыл бұрын

Summit racing wheels drag thrust

what is the name of that tole

@thedelawareranch2379

2 жыл бұрын

Rottenleoard was the name on the tool

And then wheels don’t look like 9 years old men wheels