Thank you very much for this video!!!!

Yes that's nice. But it could be better if you can make a full prosses video, like including writing back the file to a chip.

Cool video. Just wondering what does CAS stand for again? And can this tool be used if I want to clone an ECU for a car. So if one car has faulty ecu, and i buy a good 2nd hand ecu can i reprogramme the emobilizer?

what software u use to reset the hour and change power class?

Cas3++(istap use?

How many attempts to get it to connect ? It is not so straight forward

@dashtyATG

8 ай бұрын

Yes I agree

hi, vvdi prog I can do the same

Super vraiment comment je peux avoir l'adptateur pour ça

How can I get it

What do you do after you obtain the data in order to make the key???

@AutowaveLimited

3 жыл бұрын

Hi Ali, you can then load into any of your devices, such as VVDI2 and make a key!

@dashtyATG

8 ай бұрын

​@@AutowaveLimitedor you can just use KTM key tool Max. Please make full prosses video.

what do you do with the information dude

looks good but to take the cas out of a mini is 2hr job

I am practicing with this adapter, on a CAS3(0L01Y). I can not get a pin connection on the RST, CLK, XCLKS. Do I still need to get the layer of lacquer off, to get a connection?

@globalcommerce7654

2 жыл бұрын

That is something important to show in this video, why would they leave it out?? 🤔

@davidfrance2056

Жыл бұрын

Did you ever get it to connect?

@SweatyMan80085

Жыл бұрын

@@davidfrance2056 I sold the adapters. I bought the acdp package. It's much, much better.

@dashtyATG

8 ай бұрын

​@@SweatyMan80085that's what am talking about always have a back up

Great video, i just tried to read a cas3 I'm getting a message, Any suggestions? Chipcrackfailed Closevccvppower