I used two Hitec digi servos for the elevator, as prefer a dual servo setup - redundancy. Putting it together, maybe fit a Saito 170 Radial in it.

@Bravo303

4 жыл бұрын

The redundancy method is certainly a good way to go for those who have the confidence to get the geometry of the servo travel correct

Which Prop do you have?

@Bravo303

4 жыл бұрын

APC 16x6

So, c of g 150 or 160 ? thanks Paul

@Bravo303

4 жыл бұрын

Stick to the manual, if you are unsure or uneasy maybe make the plane intentionally nose heavy for the first few flights

Can you please tell me which engine and CG you used? Did you need to add any lead? Thanks. Neil

@neil4rc

7 жыл бұрын

Thank you, this is all very helpful. Neil

@beb0p858

7 жыл бұрын

I was thinking of going electric with it. But then would mean placing even more weight in the nose. Could you ask Martin's thoughts of going electric? Tell him well done :-)

@neil4rc

7 жыл бұрын

Henrik Jensen I've flown mine now and with an NGH GF30 it needed no extra weight and balanced with 2x 2s 3000 lipos under the wing at the back. Power is fine and landing was predictable and quite slow. My CG is 150mm from the leading edge of the wing before fuel.

@robertorotesi4145

6 жыл бұрын

Hallo Neil Jarvis....NGH GF30 required a big mod for installation or enter inside the cowl easy ?.....i love this model.....

@tubermick

6 жыл бұрын

I run mine with a Tacon 110 on 8S 4400 and I have lead in the tail.