No video
RAV4 5th Gen 2019 2023 Subwoofer Wiring and Stock Head Unit Removal 4K
Автокөліктер мен көлік құралдары
The obligatory disclaimer - Use this video at your own risk.
Long video, so here are some markers if you want to skip ahead:
Signal wire for sub - 6:10
Remote turn on wire for amp - 9:20
Glove box removal - 12:25
Signal/Remote wire routing - 14:37
Rear Seat Removal - 18:54
Main Power wire for amp from 12v battery - 22:08
Final wire routing - 30:59
Wire harnesses I used are available here:
tacotunes.com
It is the same harness for the Camry. If you have any questions reach out to them directly, as they were very helpful and easy to deal with. I received a response usually same day or next day at latest.
Пікірлер: 4
I needed power wire from the battery to the trailer wiring harness in the back. It was #12 and I pushed it though that inboard nipple after cutting a slit in it and then I used a sharpened point stiff ire to make a hole on the inside seal then used a solid copper house wiring as a pull wire. I soldered the wire to the pull wire and taped it, then pulled into the engine compartment. I didn't use enough wire lub and the entire grommet came out but eventually I got that back in place and the wires up to the battery. There was three wires I needed to get to the battery. One was for the trailer harness the other two was for some two way radio equipment. I do wish they would make it a little easier for us to get wires though the firewall. Thanks for the video.
Did you have to use a Line Output Converter for this?
@DoItTogether2022
11 ай бұрын
I did not. The subwoofer/amp combo I used had speaker level inputs.
@jrodmanlive
11 ай бұрын
Ah, gotcha. Do you have the link for the remote turn on harness that you used? (the 2nd harness you had to get)@@DoItTogether2022