The fault finding was very good. Even this wasn't the only fault. Great one!

The 5-legged component on the back was probably ok. The reason for the difference in diode readings is that the components you were comparing were not identical. I'm sure the two components do the exact same thing, but the manufacturer will use parts from various vendors as needed. You may have noticed the part numbers did not match. Slightly different parts, slightly different diode readings.

Was my PS4 lol. Thank you for the repair

@JoeyDoesTech

Жыл бұрын

You’re welcome 😊

Thank you for sharing

Hmm.. interesting diode behaviour. Great detective work, again

Nice job. An unrelated question: what type of iron tip do you use? This one looks pretty big! T245? Tnx

Great Job :)

Excellent! 😁

Greetings! Did the pin 3 still read as ground?

Great job mate, most people would just have changed the encoder and after still not getting an output, deem it a "no fix", I guess. By the way, what microscope are you using? The image quality is very good. I would like to buy one :D

@rocketrepairs

Жыл бұрын

IMX 385 sensor good in low light.

@der-andyman

Жыл бұрын

@@rocketrepairs Ok thanks. But wow, it is much more expensive than I thought 😮

What ticket system are you using?

I have the exact same problem on a PS4 Pro board atm. So your solution should also fix my fault. 😊 What exact type of transistor is this? Because i don't have a donor board.

What i always find surprising about the professional use of hot air is that i thought components shouldn't be heated too much to avoid damage. I've especially heard hdmi chip failures are due to excess heat/poor cooling, so the risk seems greater. Even to the extent that putting heat sinks on these is advised to prolong life.

What microscope are you using

Sir I lost one of those 4 tiny component behind the HDMI port So what is the solution for that Please help

Why tf are all these vids sped up

First