Some one who shows the facts! Finally! Thank you

Awesome looking rig! Still happy with this size a year on? not too noticeably slower gearing problems etc? Thanks

Thumbs up Neil

@withneil

Жыл бұрын

Thanks Kev!

Cheers mate I thinks it time to do mine lol gotta love W.A outback 😁 What offset did you go?

@withneil

Жыл бұрын

Hey Mick, I went with zero offset.

@mickdejager3910

Жыл бұрын

@@withneil Awesome thanks mate

0:25 what tool did you use to chop the plastic? You’ve done a really neat job 👍🏼

@withneil

Жыл бұрын

Thanks Terry. I used a small angle grinder.

👍

Looks mint 👍 Ive current running 17" zero offset and 32's and Im trying to see if I can fit 16" rims on my 2019 Prado. Any idea if a 16 will fit? I had an FJ previously and I believe the brakes are the same and had no issue with 16's on the FJ.

Great an doesnt look too hard! 0 offset wheels definitely required over the stock wheels?

@withneil

Жыл бұрын

Yes, 0 offset wheels required to run these tyres.

@maximmalkin6110

9 ай бұрын

What if new control arms are being installed? They put wheels further away from the body. Would these tires fit on stock rims in that case?

Did you have to chop anything off the front bumper? I’m looking to put 33s on but the tyre place is saying they won’t fit but I look at yours and they do haha I won’t give up

@withneil

Жыл бұрын

Nope. Didn’t have to chop the bumper. I had to pull the bottom part of the plastic liner towards the front of the car though. Takes 5 mins

@nathangrundy7230

Жыл бұрын

@@withneil oh awesome thanks mate

Hey Neil, looks good. What year is your Prado? Looking at the same size tyres (Wildpeaks) with ROH rims. One tyre place said +12 offset should be right up to the edge of the guard. A zero offset would have some poke!

@withneil

Жыл бұрын

Hey @Lydenmad! Thanks. It’s a 2015 with 2018+ tail lights. +0 does poke out a little 😜

What suspensions did you install?

@withneil

10 ай бұрын

Dobinsons monotube IMS

These will 100% rub the minute he takes it off pavement. You can see the front bumper ready to get beaten when he's under some compression and articulation.

@withneil

Жыл бұрын

Hi randomuser6306, I’ve never had issues with this setup while dune bashing, beach driving, in mud and on rocks. If you’re talking from your personal experience and have pics/videos to show, I’ll happily add a note in the description about potential bumper damage.

@randomuser6306

2 ай бұрын

​@@withneilwhat's your wheel offset? I've got -25 and the 265/65s rub on the body mount and fender. Had to remove mud flaps and trim much plastic. Dune bashing in the UAE, so lots of speed and momentum, angles and impacts.

Ground clearance?

@withneil

6 ай бұрын

Yes, around 2.5 to 3 inch higher. More than enough for most 4wders.

With 2 inch lift will it fit 295 70 17?

@withneil

Жыл бұрын

Hi Igor, I’m not sure mate. Never tried it.

@michaelferguson651

Ай бұрын

No it wont

what's the biggest tire I can put on stock suspension?

@Bad_Rattle

Жыл бұрын

31.6” and still rubs depending on offset. My 265/70r17 on -10 Volk TE37’s rub on the inner liner of my GX460

@e36boy

Жыл бұрын

@@Bad_Rattle thanks! Planning on a 17 inch wheel setup too.

@karipintakivi9153

Жыл бұрын

I have 265/70R17 BFG AT Ko2 on 7" rims and -10 offset, no rubbing. I think those are the biggest without modifications.

So the answer is no

They will wear themselves in jaja

Speedo must funny as fuck.

@karipintakivi9153

Жыл бұрын

Will show too little. WIth 265/70R17 mine shows +0.5 at 80 km/h and +1 at 100 km/h. Perfect and legal.

@wasitbagtittyfckdriving.3840

Жыл бұрын

@@karipintakivi9153 Ok thanks so which size should I go for when I doing the upgrade?

@angeloudy

Жыл бұрын

You only increased the diameter by 6.9%. It must be as accurate as GPS now.