How did you check your mobile for various car problems? Do you have any suggestions for Honda?

Please make a video on Airbag light also

My vento tdi does increase its rpm under load sometimes and upon checking the voltage it's around 14.7 on idling and 14.0-14.2 under load. Is it normal?

@yourDIYneeds

Жыл бұрын

Perfectly fine

Hellos, I'm having a problem with my WV polo 1.2 tsi which I was changing suspetion. Then after the Cas steering is hard and have a red light of power steering on the dashboard... It talks about angle sensor when diagnosed...

@yourDIYneeds

10 ай бұрын

Sir was the alignment done in the right manner ?

@leftshivambuwakanghamula9459

10 ай бұрын

Yes, I took it to 3D alignment

@yourDIYneeds

10 ай бұрын

Can you tell me the exact code you are getting sir ? Because i want to know , whether the angle sensor is reading wrong angle or it's not working .

@leftshivambuwakanghamula9459

10 ай бұрын

P160900 B201000 U042800 Here are the codes

This is how troubleshooting is done! Instead of disconnecting the MFD, can we disconnect the battery to reset the modules?

@yourDIYneeds

Жыл бұрын

Sir yes it can be done , but battery needs to be disconnected for at least 15-20 mins , because almost all modules have capacitors and they can store a little bit of energy for some time , so we need to wait until those caps are drained

@generalgriphineworldboss1811

Жыл бұрын

@@yourDIYneeds thanks

My garage guy insisted me to put 0w30 fully synthetic engine oil in my 2015 vento Diesel is it good oil

@yourDIYneeds

Жыл бұрын

Sir have a look at this video - kzread.info/dash/bejne/imGnsJulisadqZs.html

Bro swift diesel 2014 ke liye castrol 15w 40 engine oil kaisa rahega?

@yourDIYneeds

Жыл бұрын

Sir 5w40

@ishantyagi6951

Жыл бұрын

@@yourDIYneeds castrol or shell?

@yourDIYneeds

Жыл бұрын

Sir shell

Sir video please in hindi and please tata safari aur video bnao

Bhai g hum Diesel swift mai shell 10w40 engine oil bhi use kar sakte hai kya?

@yourDIYneeds

Жыл бұрын

Hanji sir bilkul

@ishantyagi6951

Жыл бұрын

@@yourDIYneeds thanks bro bhai... You tube pai bus apke he channel pai reply aata hai.thanks bro keep it up

Hi. I get an error under Central Electronics like: 01598 - Drive Battery Voltage 000 - - Freeze Frame: Fault Status: 01100000 Fault Priority: 3 Fault Frequency: 1 Reset counter: 27 Mileage: 164624 km Time Indication: 0 Date: 2017.08.12 Time: 06:37:45 I tried clearing it, but the error came back again. Sometimes the car idles a bit high (1000 rpm instead of 900 rpm) and the radiator fan spins at full speed. Numerous forums tell it’s a faulty alternator or battery. Just few months back, I got my battery changed. The voltage hovers around 13.5. Check after overnight, the voltage was at 12.7. Any idea what issue it might be?

@yourDIYneeds

Жыл бұрын

Sir , can you tell me which vehicle you exactly have , because a lot of vehicles may require you to code the new battery as per the specs of the new battery , so that the alternator can adjust itself for charging

@doczilla1023

Жыл бұрын

@@yourDIYneeds Thanks for the reply. It’s a 2012 1.6 TDI Vento. Does PQ25 platform require battery coding like MQB?

@yourDIYneeds

Жыл бұрын

No sir, PQ series of BCMs doesn't require battery adaptation, alternator has a specific part called " voltage regulators" which can go bad , but that doesn't make the voltage reading "000" , it will start to throw out either massive amounts of voltage or no voltage at all . If there is no issues with the engine cranking , and alternator is doing its job of charging the battery and powering the electronics , then it can't be alternator . What i feel like is , its more of a fault with the voltage reading circuit of the BCM itself , because at the end of the day , both ECM and BCM are nothing but just very advance Multimeter which has the capabilities to send and receive signals multiple times per second . If voltage is low then it will throw a code but that's not the situation here i guess. So either the transmission end of the stream is bad or the receiver end , in both of the case we will get the same code . Hope i made a valid point to understand .

@doczilla1023

Жыл бұрын

@@yourDIYneeds Thank you so much for the input. I’ll test it out and let you know of the results.

@doczilla1023

Жыл бұрын

@@yourDIYneeds Hi, I took out the negative terminal off the battery for about 5 mins and put it back on. Cleared the error code and it didn’t come back. Thanks a lot. One more query. Is it bad for Camshaft position sensor to be higher than 4.8 degrees? I got timing belt replaced earlier and still the values sits at 5.25 in warm conditions. Could it be a bad sensor or timing needs to be rechecked?

Thank you for this info. Which app are you scanning with?

@yourDIYneeds

Жыл бұрын

Sir OBDeleven device and their app

sir any body repairing powersteering modules

@yourDIYneeds

Жыл бұрын

Sir , it won't get successful

Hello there, i want to get Punch remapped, will it be safe? Watched your video

@yourDIYneeds

Жыл бұрын

Sir , it will be safe but not that reliable

@piyushkanthak1087

Жыл бұрын

@@yourDIYneeds will something happen to the engine? I just want to get rid of the lag and improve driveability that's it, no high end remaps

@yourDIYneeds

Жыл бұрын

It will improve driveability, can't say anything about the lag , because it depends upon engine to engine

The MID of my polo is getting dimmer from the right hand side the intensity of the MID light is lower from right side...How to fix it?

@yourDIYneeds

Жыл бұрын

Sir , screen replacement can be done but finding the right screen will be a task

Safari dicor pr video banao

Bro , can you share the link for vcds hex cable ?

@yourDIYneeds

Жыл бұрын

Sir you check their official website and check for price and do let me know the price , because i have a person who is into these things , then afterwards i ll confirm from him , whichever will be less expensive , you can buy from that source

Hello, i have a audi a3 2004 it is saying sometimes that it don't have communications with the steering module incheckt the wire and fusses.. some times it works. Does the steering module is going bad.? Or can it be the steering sensor.?

@yourDIYneeds

Жыл бұрын

First is to make sure that the steering module is getting proper voltage , Check continuity for grounds , as half of communication faults are just because of drop in voltage . And check the electrical connector of the steering module for any corrosion buildup

@antoniaydin

Жыл бұрын

@@yourDIYneeds i have checked the wires expect on the steering house because it is hard to get there. Is the module at this type at the steering wheel?

@yourDIYneeds

Жыл бұрын

Then try scanning the module and check the resistance and power voltage on the module from the diagnostic tool .

@antoniaydin

Жыл бұрын

@@yourDIYneeds i wil try i have now autel my vcds it not working. And do you know where the module is?

@yourDIYneeds

Жыл бұрын

Module no. 44 Go in live data and check the parameters

Brother there is no video on Tata safari, did you sell your vehicle or any issue with vehicle?

@yourDIYneeds

Жыл бұрын

Sir i gave it to my cousin, as we can not drive any diesel vehicles which are 10 yrs old in national capital

@omkarugalmugle9379

Жыл бұрын

@@yourDIYneeds OK bro,, but missing d beast,, u know what it feels 🙌

@yourDIYneeds

Жыл бұрын

Yes sir

Where do you get the security code for coding ?

@yourDIYneeds

Жыл бұрын

Sir they are available in obdeleven platform and if they are not then you can search for it

Sir my safari dicor 2.2 model is having starting trouble .... He is not starting in first self after 5 min of rest he start but service light is continuously started when engine is ON

@yourDIYneeds

Жыл бұрын

Have you checked glow plugs ?

@rudrakshatayde2824

Жыл бұрын

@@yourDIYneeds no I have not check but is that only the issues or other one because after the engine start car not automatically off but when we off the engine and then trry to start it's not starting and after same time it's started so glow plugs is the issues????

@yourDIYneeds

Жыл бұрын

Sir had car ever ran without fuel , air got into the fuel system ?

@rudrakshatayde2824

Жыл бұрын

@@yourDIYneeds yes... Not run but trying to start

@yourDIYneeds

Жыл бұрын

Sir may have to check the pressure of high pressure fuel pump

Difference between VW 505 00 and VW 505 01... Will they make any difference?

@yourDIYneeds

Жыл бұрын

Yes sir approvals are formed on the basis of presence of specific additives, they make a lot of difference in longevity of the engine

bhai ap apni video England mai ja ke bnaye. Q k yahaa jiyada log Hindi samjhte hai. agar ap genuinely kisi ki help karna chahte ho to language ka dhiyan rakhe. thnx

Tata safari drag race

Hello, How are you and how to contact you??

@yourDIYneeds

Жыл бұрын

Sir i am doing good , hope you are also doing well, you can contact me on my mail everydaydiyhelp@gmail.com

Which app is this ?

@yourDIYneeds

Ай бұрын

Obdeleven

13-46 to 13-56 after start the car., You changed the polarity + & - 😆😆

@yourDIYneeds

Жыл бұрын

Sir i was basically testing voltage and continuity In continuity polarity doesn't matter In Voltage it does but it shows reading in -ve And i was sure that alternator is producing power not drawing it 😅😅

Sir, Skoda Octavia 2010 lift back model, the steering is stlff. This happened a day after i serviced the car. The EPS signal is off on the dashboard, no yellow or red light on. What is the problem.

@yourDIYneeds

2 күн бұрын

Sir get it scanned first, if there is any code or not . And check the live data for the voltage received at the steering module , it will give us a Direction to work in

@oluseyiadefisayo1142

2 күн бұрын

Thanks, I will get it scanned as advised but please where and how will I checked the voltage received from the steering module?

@yourDIYneeds

Күн бұрын

@oluseyiadefisayo1142 The scanner can read the voltage provided to modules

@oluseyiadefisayo1142

9 сағат бұрын

Thank you boss. I scanned and the steering is now free and smooth. It's no longer stiff. Though it gave error code but it was resolved. Thank you

I just charged my battery up and the fault light was gone. New battery would also s=resolve this issue.

@yourDIYneeds

6 ай бұрын

Yes , voltage issues can create the issue

15.8 volts at idle is a faulty generator.

Have you sold you Safari? 😰

@yourDIYneeds

Жыл бұрын

Sir gave it to my cousin , as it was 10 yrs old now and we can't drive a vehicle which is 10 yrs old in national capital

@prateikmallik

Жыл бұрын

@@yourDIYneeds hope you meet your cousin soon and make some videos❤.. Your safari's videos were stress-buster😅

@yourDIYneeds

Жыл бұрын

😂

What’s the cost of OBDeleven n from where you bought? I have VCDS HEX-NET right now

@yourDIYneeds

9 ай бұрын

Sir if you are using Android then its for €40 If apple then €60

Can use the same fix for golf 7?

@yourDIYneeds

Жыл бұрын

Yes procedure is exactly the same

@AnanDElam

Жыл бұрын

@@yourDIYneeds thanks boss, I'll go try now. I have same issues. Red steering. But sometimes its fine... Sometimes it makes this problem.

@AnanDElam

Жыл бұрын

Unfortunately on my golf that did not resolve the issue. The red steering light still comes up

@yourDIYneeds

Жыл бұрын

Tried disconnecting the cluster ?

@AnanDElam

Жыл бұрын

@@yourDIYneeds yes... I disconnected the cluster.... And connect it back after 5 minutes. Didn't work, now left it disconnected and batteries are disconnected too now .. i will connect it in the morning and see how. Is there other fix for this?