Polaris RZR XP 1000 Engine Rebuild | Part 6: Engine Installation
Тәжірибелік нұсқаулар және стиль
Whether your Polaris RZR XP 1000 is burning oil and in need of a top end refresh or you had a catastrophic engine failure that resulted in a complete top and bottom end rebuild, we've got you covered with our RZR XP 1000 Engine Rebuild series. In part 6, Charles finishes up the rebuild by showing the proper procedure for engine installation as the freshly rebuilt motor goes back into our Polaris RZR XP 1000.
Shop Now | Polaris RZR XP 1000 Engine Rebuild
www.rockymountainatvmc.com/Sa...
Watch Next:
Polaris RZR XP 1000 Engine Rebuild Series
• Polaris RZR XP 1000 En...
Check out www.rockymountainatvmc.com for all your parts, apparel, and accessories!
Click Here To Subscribe To Our Channel!
/ @rmatvmc
Follow Rocky Mountain ATV/MC On Social Media!
FACEBOOK: rmatvmc?utm_...
INSTAGRAM: rmatvmc?ut...
TWITTER: RMatvmc?...
0:00 - Introduction
1:10 - Tools & Parts
2:59 - Exterior Assembly Components
4:17 - Engine Placement
5:05 - Transmission Attachment
6:05 - Center to Center Distance
8:08 - Motor Mounts
10:14 - Assembly Attachments
12:28 - Heat Shield
13:39 - Assembly Components
16:22 - Clutch
20:40 - Cargo Bed
22:02 - Roll Cage
Пікірлер: 12
Very helpful series rebuild my whole engine with these videos
@rmatvmc
5 ай бұрын
Nice work! Glad the videos were helpful.
You’re the best! Makes something that may seem impossible very easy for people that are mechanically inclined!
Great information just redid my motor, and this was helpful.
If you are looking to replicate Polaris RZR OEM factory assembly be sure to leave a few bolts loose & atleast one bolt & nut completely missing.
Great video series!!!!
@rmatvmc
3 жыл бұрын
Glad you like them!
Great info, i would of made sure i had oil pump op to the head before starting it and would of been great to see you start the motor 🙏👍
Wouldn't it be a good idea to leave the injectors and coils Unpluged & crank it untill the oil pressure light goes out then reconnect the coils & injectors Then go ahead fire it up!
Are there any at home alignment methods we could use other than getting that set up that looked expensive.
Why isn't the drive shaft splined?
Elon Musk?