Hi there, thank's for this video...Very explained...in my case there was no issue to change " NTF_DISPLAY" but Oled screen run AFTER uploaded the last version for quad 4.1.1 on Mission Planner....Very good ... Philip

I CAN not see this specific parameter in the list, all other parameters are there. why is that ??

I tried to add this onto my IRIS+ , But there wasn't the option to select the display.. So i did an update, and when i did this,, then it said the board wasn't recognized.. So i had to revert back to the older version.. I'm Guessing my Pixhawk cannot handle the newer version of software. What to do ? I love my IRIS+

@electronicproject1205

3 жыл бұрын

You should re-install fmu3 firmware for your pixhawk flight controller.

Looks like a great addition, I can’t see what is on the display

@OneTwo-wt8qv

3 жыл бұрын

Yeah they aren't very useful just COOL >!!!

@electronicproject1205

3 жыл бұрын

No in the LCD they Display information about drone. Such as GPS status, Flight Mode, Battery, etc.

@OneTwo-wt8qv

3 жыл бұрын

@@electronicproject1205 YEAH I know I use them too .. BUT its TINY lettering .. Thats what we are talking about ..

PODEM CONFIAR COMANDO TOTALMENTE CORRETO! HAAAA LOWWWW BRASILLLLLLL.....🤪🤪🤪