These have been around for years only we had a lever to operate the hydraulic ram cos we were miles tougher in them days than the plastic pipe fitters today, 2''bsp was a big ask when making expansion loops on steam mains, got yer ready for a few ales after work though,,,,
@francescor.49394 жыл бұрын
Pressure in cylinder?
@agismailagabdrahman2571
What no hydraulic oil?
@chavink13 жыл бұрын
How do you control the length or bending angles
@payalsaxena36093 жыл бұрын
Payal saxena
@vanlinhnguyen47585 жыл бұрын
You should make its stronger by change structure of frame . It will be broken if under more pressure from hydraulic machanism .
@Dan-gk7ti2 жыл бұрын
Do the same with Exhaust pipe and after less than 20 degrees in the bend, the outer middle of the pipe in the bend will flatten and squash inward ! Need a Dye to stop it crushing !
@baburamabadhran14373 жыл бұрын
is it usable for 1.6mm thk, pipes and 6 inch Bending radius. Do you have a manual hyd. operated.
@sohanmalhi35045 жыл бұрын
Hi, where can I buy it from?
@Iwan-vi4il5 жыл бұрын
Perfect, try the square one
@08redjenking6 жыл бұрын
can it bend tube or only pipe?
@diycraftsman223 жыл бұрын
Graet work
@gogosinghgogasingh82985 жыл бұрын
Very good
@charlesdarby91425 жыл бұрын
Care to use to make me a manifold for my 1938 Allis Chamblers model U tractor
@williamcarrero21205 жыл бұрын
buen dia. que dobladora tan genial, una pregunta cual es el radio de esa curva
Пікірлер: 118
Why didn't it kink?
These have been around for years only we had a lever to operate the hydraulic ram cos we were miles tougher in them days than the plastic pipe fitters today, 2''bsp was a big ask when making expansion loops on steam mains, got yer ready for a few ales after work though,,,,
Pressure in cylinder?
What no hydraulic oil?
How do you control the length or bending angles
Payal saxena
You should make its stronger by change structure of frame . It will be broken if under more pressure from hydraulic machanism .
Do the same with Exhaust pipe and after less than 20 degrees in the bend, the outer middle of the pipe in the bend will flatten and squash inward ! Need a Dye to stop it crushing !
is it usable for 1.6mm thk, pipes and 6 inch Bending radius. Do you have a manual hyd. operated.
Hi, where can I buy it from?
Perfect, try the square one
can it bend tube or only pipe?
Graet work
Very good
Care to use to make me a manifold for my 1938 Allis Chamblers model U tractor
buen dia. que dobladora tan genial, una pregunta cual es el radio de esa curva
Nice 👍
Will it work on 2mm pipe?
Como vocês fazem para saber o grau que está ?
How much is this tool and is that tubing or pipe