Working on a Scottish car,3 full shifts and the box still isn't out,using every trick in the book just to get bolts loosened...kudos to you,what a nightmare job as a living!

What a guy, changing a transverse clutch laying on the ground... no lift!

@bartka8

Жыл бұрын

"Mobile" :)

I just wonderring if my Peugeot 308 1,6 liter HDI from 2012 is single mass or duall mas flyweel.?Thank you

I was going to tackle this job.. but I think I will stick to doing the drive shafts

I was doing a 308(t9) GTi yesterday and when I was wiggling the box out the jack slipped engine dropped with gearbox about an inch clear. Dropped engine about 5 times trying to get it back into position. Gearbox is back in now. Do you reckon everything will be ok or damaged mountings or bent input shaft?

I've been trying to remove my gearbox, but I can't seem to find the top bolt for the starter motor. Mines is the 308 mk1

@MobileClutchRepair

Жыл бұрын

Hi there 2 bolts are located behind the starter motor one is kind of hard to get too. Remove the cable from the motor itself to allow access 13mm nut. And the last remaining bolt is the opposite side next to the top bell housing bolts.

What is he doing. It's like a 1st day a apprentice