Parking Sensors NOT WORKING... TRY THIS 1ST
Автокөліктер мен көлік құралдары
Parking Sensors NOT WORKING... TRY THIS 1ST
To know which sensor doesn't work, insert the key into ignition and switch to position 2 then put the car into reverse. step out of the car and go to the parking sensors and touch each one individually and see which one is "sparkling" less than the other ones. You may have 1 or 2 or who knows maybe all (in which case you either have a wiring problem because you can't know which sensor is bad or they're all bad and need replacing). Its good to take them out from time to time (twice a year would be perfect) and clean with WD-40 or any other spray which doesn't leave residues
For more information on WD-40 go to wd40.co.uk/
Thanks for viewing
► LIKE & SUBSCRIBE for MORE DIY VIDEOS that could SAVE YOU BIG £££ €€€ $$$
Also click the link below for my Car Lovers T-shirts & Accessories
tee.pub/lic/HD11nn0RQaQ
Пікірлер: 77
Hallelujah, praise the Lord bless you amen. This did not work straight away yesterday evening, but this morning I tested the car and I couldn’t believe my ears, the rear reversing sensors now up and running and functioning in the way that they were designed to function. Bless you bless you bless you
@kenshumba6454
9 ай бұрын
😂😂😂😂😂
Worked first time on my 2018 Renault Clio 👌🏼 thanks!
It worked !! Thank you very much for posting this
Just did mine on a Jag, I sprayed once left for 5 mins and sprayed again, now working perfectly, great tip 👌
@JFKKARZ
2 жыл бұрын
Good work, thanks for the positive feedback. 👍
Amazing, worked directly after the first try. Thank you for saving me some money!
thank you! worked on 2nd try! 2016 Rav4
Worked first time on my wife’s Kuga. It’s been driving her nuts for months. Garage said whole bumper had to be removed to replace it. £££££££££
@JFKKARZ
Жыл бұрын
JFK KARZ 8 months ago Glad to help, thanks for the positive feedback 👍
@hyacinth1966
Жыл бұрын
hyacinth1966 1 second ago Hallelujah, praise the Lord bless you amen. This did not work straight away yesterday evening, but this morning I tested the car and I couldn’t believe my ears, the rear reversing sensors now up and running and functioning in the way that they were designed to function. Bless you bless you bless you
@johnblewitt4653
5 ай бұрын
😢🎉it8,, 1980s @JFKKARZ
Gracias pensé que era algo más grave ,lo hice y funcionaron de nuevo.para el audi A4 👍👍 saludos desde Chile.
Worked on first attempt clio 2015! Thanks mate
2014 Mini - five minutes - sorted. Thanks JFK!!!!
I did this by spraying WD40 and it worked for a few days only, after that I did get random beeps again, I also noticed one of the sensors was partly peeling off paint, about 1/3 of circle area like the sensor of the display picture of this video, I have repainted the whole circle area of the sensor with an even coat and now is working properly.
Thought ide share. Same happened on my 2018 vw tiguan , but before one sends it to garage please try this yourself, as i did today by pure accident and it fixed issue in your vid. Go to screen above steering wheel and turn off all assists, on my car it has two including lane assist, click those boxes so no tick shows, i waited 6 hours to go for drive (as i had an issue and manual says switch off front assists, so i did), but just for whatever reason i clicked on front assists and BINGO Wahooooo it reset itself. Still can't believe it but if that doesn't work yes you need to take it to the garage and get fixed. I forgot to mention i cleaned all my sensors but still error front pilot showed on screen and flashing at the P button. All fixed and with by reading my manual and by pure luck. Very happy and hope this helps. Remember i only turned off assists as i had a problem and manual advised me to do so, they thankfully are back on now and i saved a fortune.
WD 40 works for me just 5 minutes ago after watching another video, thanks
Tebrikler. Bunu deneyeceğim.🎉
it really helped
It worked for my lexus rx 350 2010 model, 👏 thanks
@JFKKARZ
2 жыл бұрын
Very good 👍
Wow it worked
There's also a parking sensor module for some reason when i unplug my reverse light bulb the sensor's start working very strange and i wish it was the other way round as i have an mot coming up soon.
To know which sensor doesn't work, insert the key into ingnition and switch to position 2 then put the car into reverse. step out of the car and go to the parking sensors and touch each one individually and see which one is "sparkling" less than the other ones. You may have 1 or 2 or who knows maybe all (in which case you either have a wiring problem cuz u can't know which sensor is bad or they're all bad and need replacing). Its good to take them out from time to time (twice a year would be perfect) and clean with WD-40 or any other spray which doesn't leave residues, because you're driving on all sorts of roads starting from dusty ones to wet ones and all that mud is going to clout in the sockets and cause PDC to malfunction.
@eddieathers2488
Жыл бұрын
Put the car in reverse and get out the car you say?😱
@ovegustavhellandsj7438
Жыл бұрын
@@eddieathers2488 Not very dangerous when the enginge doesn`t run, is it??
@LingoENT
Жыл бұрын
I crashed my car
@Dragosn7
Жыл бұрын
@@eddieathers2488 position 2 not 3😅
@shanelee8779
Жыл бұрын
It’s not dangerous if the engine isn’t running, in fact if you’re parked facing down on a hill, the reverse gear won’t hold your car with the engine off. Basically just chock off your wheel/s first before doing that, that’s if it’s like my car and the hand brake or ebrake needs to be released to activate the sensors. But either way it’s better to chock the wheels
would a electrical spray cleaner also do
Are you're reverse lights working? If not could be the reverse sensor switch.
@leedonalds
Жыл бұрын
Mine didn't because reverse lights didn't work put new switch in lights on but no sensors
My vauxhall mokka does not beep at all and says need service. I would ideally want to avoid goong to vauxhall as i know thats going to cost a lot more than necessary.... any ideas?
Yes it is good information just minutes.😅
@JFKKARZ
11 ай бұрын
Glad you liked it
My caravelle T 6.1 front right sensor wont stop going off when nothing is near on the open road 😂 😤
Mine are not even making noise, tried the wd 40, no help, may be the module??
@wallychambe1587
2 жыл бұрын
Fixed mine by replacing the beeper speaker in the rear deck😁😁
If this fix with WD40 dont work, you can turn the ignition on and put the car in reverse and walk back to the sensors and listen if they make a clicking noise. If they dont, they probably needs to be changed. Hope this helps somone. Have a great day yall 😊
@JFKKARZ
2 жыл бұрын
I know. See my other videos 👍 all the best
@PaulA-be7ww
Жыл бұрын
For all who read this comment, turn the ignition switch to on position but the vehicle must be off. I.e: engine should be off. Do not step out of the vehicle otherwise
Making mine not work is what I'm trying to do👍🏾😁
@JFKKARZ
Жыл бұрын
Take the fuse out. 😉
@simonesaidy
Жыл бұрын
Press the switch off button under the steering wheel.
l had continuous beeb now after this hack lve got nothing so will probs have to remove the rear bumper and replace sensors
@JFKKARZ
Жыл бұрын
Like it says, try this first.. if not it could be a faulty sensor.
I'll give it a try..... Take care of your car better. Wipe that DW40 off all the bumper area. A little sloppy but good idea how to fix
After a heavy rainfall, rain seems to get inside the sensors and causes them to malfunction . A Couple of days of warm weather/direct sunlight usually fixes the issue or you can do what I did.. I used a portable vacuum (18v Milwaukee) I put the hose on the blower side of the vacuum and used a crevice attachment (this increases the speed of the air) and aimed it at each sensor while varying the angle of directed air and it worked. No direct contact between the vacuum attachment and car panels/bumbers.
@JFKKARZ
2 жыл бұрын
Another top tip.. 👌 thanks for that.
@Naessey
2 жыл бұрын
I find this error occurs after heavy rain. If I clean out, use blower and WD40, then wait a few days when warm weather back, fault disappears. Has worked last 4-5 times. Not to say this will work in the future as wear and tear occurs. When I use the blower, always amazed how much water there are in the sensor gaps. Anyhow, give it try. Can’t hurt.
Not working on mine. Pitty...
Can someone please help me. My sensors are working intermittently. One moment they will act normal then the next time they will been continuously then another time they will do the close rapid beeping. Now all of this will happen when I’m not near any thing
If you guys want more efficiency and long time take wd40 waterproof
Does wd40 eats the paint?
@JFKKARZ
2 жыл бұрын
Hi No this will not damage the paintwork as you only leave the WD40 on the paintwork for 5 min
@smashrc123
2 жыл бұрын
@@JFKKARZ ok thx
@wallychambe1587
2 жыл бұрын
Wipe it off!
@christopherbrown2224
2 жыл бұрын
It’s a degreaser not paint stripper
😂😂
A video to show a "fix" that dont work!!!!! How brilliant is that!! Took some thinking that did!!!
@isab958
4 ай бұрын
How ungrateful. Didn’t see your video explaining that this is a first fix.
@brooklyn2376
4 ай бұрын
wow awesome reply 🙄 he's obviously trying to help others..
@glennsharkie4882
4 ай бұрын
Your sad
@brooklyn2376
4 ай бұрын
@@glennsharkie4882 of course I am 😂😂😂😂
WHY does it work though???
@adamg1711
Ай бұрын
WD40 dissolves and rinses dirt
🤡🤦🏼🤣
Don’t work
@JFKKARZ
2 жыл бұрын
It's a first try, So you need to check all your sensors, and replace. Or check the wiring on the faulty sensor.
@elliotclarke5149
Жыл бұрын
Worked for me
Left all that wd 40 all over the paint, running down the bumper. 🤦♂️
Hi can wd 40 damage car paint ?
@JFKKARZ
Жыл бұрын
Hi not in this process, but for more information click on the link. wd40.co.uk/