Overview of the Arduino Nano V3.0 controller. This video provides a brief description of the controller's capabilities and the required minimum set for getting started. Also shown is the process of installing the driver for arduino and the development environment for programming the controller. After installing all the necessary components, load the test sample into the controller and check its operation.
Specifications Arduino Nano V3.0:
- ATMega328P controller
- 14 digital inputs / outputs (6 of which can generate a PWM modulation signal with a resolution of 8bit)
- 7 analog inputs (5 of which can be used also as digital) with 10bit resolution.
- 2 inputs for processing interrupt signals
- Supports UART, I2C and SPI interfaces.
- The frequency of the controller is 16 MHz.
- Supply voltage 6-20V (Recommended 7-12V).
In order to start working with the controller on the computer, you will need:
Install the driver for Arduino Nano: www.wch.cn/down...
The Arduino development environment: www.arduino.cc...
Order the Arduino Nano board: ali.pub/33qe7p
Development board: ali.pub/33qerc
Connecting wires: ali.pub/2e5hzx
USB cable: ali.pub/2e5iie
Join the VK group with daily updates: buychin...