Operate Camera On Laser Engraver | Tutorial | MIRA9 | AEON
Ғылым және технология
Hello everyone! Last time we finished the two wizards for camera setting, and in this video we will give you a step by step tutorial about how to operate camera on your laser machine!
We would love to see you share your works with us in the comments!
Follow us for more
▶KZread: / @aeonlaserofficial
▶Facebook: / aeonlasercn
▶Facebook Group: / aeonlaserglobal
▶Instagram: / aeonlaser.official
▶Official Website: www.aeonlaser.net
#aeonlaser #lasercutting #laser #setup #setuptour #camerasetting #co2laser #mira9
Пікірлер: 7
Hi. How does the camera works? I have it preinstalled by you but i don`t see it in Lightburn?
@aeonlaserofficial
Жыл бұрын
Hello there, please make sure that you plug the wire in machine and then you could find it in lightburn: Window-Camera control, you could watch this video: kzread.info/dash/bejne/m4Gqp82vltO8kc4.html
Hi what camera are you using for the Mira 9?
@aeonlaserofficial
Жыл бұрын
Hi Stan K, about the camera, actually any camera with an angle of 90 degrees and more than 500W pixels would be fine. Lightburn sells this type of camera themselves too.
@stank9203
Жыл бұрын
@@aeonlaserofficial can you recommend which Lightburn camera will work best on the mira9 using a Mac ?
Same mira 7 ?
@aeonlaserofficial
Жыл бұрын
Hi there, and yes sure pretty much the same