Onan Code 14/15 FIX

Автокөліктер мен көлік құралдары

I saw someone struggling with a Code 14 on their Onan 7000 Gas generator. Here is a quick video showing you how to correct a Code 14 and Code 15.
Tools needed:
www.amazon.com/hz/wishlist/ls...
C-YA

Пікірлер: 9

  • @davelipanovich2661
    @davelipanovich26617 ай бұрын

    Great video, thank you. Exactly the issue I’m having right now…..

  • @bdmitx
    @bdmitx4 күн бұрын

    Awesome hope it fixes mine ! Keeps shutting down after about 10 min with the code 15 cross my fingers

  • @stevenfoisy6260
    @stevenfoisy62602 ай бұрын

    Been having issues with overheats last summer and now this 14 code thank you for showing how to adjust this!

  • @2009reezen
    @2009reezen6 ай бұрын

    Good info, it would be nice if you did a close up to show the bolt, threads, basically a visual to what its going to look like. I have the 4000 and it just started to give me the 14 code. Hopefully I can find this without having to remove the generator.

  • @user-oz1ll7ld9f
    @user-oz1ll7ld9f24 күн бұрын

    Hello, how are you I have Onan 4000 and I have a problem. Please help me

  • @dougmittleberger8802
    @dougmittleberger8802Ай бұрын

    Nice!!

  • @Raskzi
    @RaskziАй бұрын

    My Onan is a 5500, hard to start but when it does on for a couple seconds then turns off. Code 14. Not enough time to get a reading.

  • @dougmittleberger8802
    @dougmittleberger8802Ай бұрын

    Thanks for video just adjusted the 10mm and now it runs just have to adjust hrtz

  • @carlbeaver7112
    @carlbeaver711218 күн бұрын

    Age (hours), dirty air filter, generator brush condition (shouldn't but can), slipping belt (bad tensioner, etc), valves need adjustment... basically anything that can affect performance/RPM of the genset will alter the frequency it outputs. It wants to stay in the 60Hz neighborhood because that's where U.S. devices are engineered to operate. Engine/generator RPM determine frequency, sooo... The additional adjustments available allow more control over various other conditions. ALSO - Nylock nuts are a mix of good and bad. They work great for a once and left alone forever, in one place setting but start adjusting them a couple times and they will stray. Best bet is to either replace that nut or install two standard nuts together to lock them together and prevent possible loosening.

Келесі