Old Horse Troy-Bilt Tiller Drive Belt Replacement - They Don't Make Them Like This Anymore
Тәжірибелік нұсқаулар және стиль
Old Troy-Bilt Horse Tiller Drive Belt Replacement - They Don't Make Them Like This Anymore. Do it yourself. Save money. Fix your old garden tiller.
Drive Belt: amzn.to/3P74s0g
Youtue Channel: / @therustichandyman
Thank you for visiting my KZread channel. Please understand that the content on this channel is intended for informational purposes only. I make no warranties about the completeness, reliability and accuracy of this information. Any action you take upon the information posted on my KZread channel is strictly at your own risk, and I will not be liable for any losses and damages in connection with the use of my KZread channel.
As an Amazon Associate I earn from qualifying purchases.
KZread Channel: / @therustichandyman
Contact me at: rjlifeworks@gmail.com
Thanks for watching!!!
Пікірлер: 17
This is a useful video to learn how to remove the engine from your tiller, however, you don't need to pull the engine off. You can replace the belt in 5 minutes by just moving between forward and reverse gears to pull it out the back and put a new one on.
Its been a minute since ive replaced belts on a horse, but all i ever did was use a small pry bar, worked out the old belts and then worked in the new belts. 20 min tops. Ive done several that way. Feed it out and back in from the side that is open. Belt number GW-9245.
no need to pull the engine
This is good. I need to take my motor off so I can replace the front transmission seal. I also have new OEM Troy Bilt belts to put on just because.
I have a 1980 no need to remove engine
Thanks !
Nice
I wonder if two belts can be used mines doing the same even thought I changed mine only two uses ago
@therustichandyman
4 ай бұрын
Maybe you just need to adjust the tension…
@catsbyondrepair
Ай бұрын
Only one is used for the the two speed pulley.this is a old single speed pulley
My tiller tried to run away on me. Maybe I need to learn the technique or is there something wrong with the machine? Everyone makes it look easy.
@therustichandyman
3 ай бұрын
Depending how hard and dry your ground is, you might want to start out tilling a little bit shallow. You can adjust the time depth at the rear.
@thedillestpickle
3 ай бұрын
@@therustichandyman Ok thank you. It is a grass lawn that has just been grass for decades. Not quite dry. I will try scraping down layer by layer and see how that goes. I just got the tiller a few hours ago, so I should probably do a once over on things like the carb and engine oil, and then give that another try. Thanks!
@therustichandyman
3 ай бұрын
@@thedillestpickle you will definitely need to start super shallow and gradually increase your depth. It will take several times going over it if it’s just been grass.
Damn dude you didnt need to do all that
@therustichandyman
3 ай бұрын
I realized that later. But it was good practice for future repairs!