Instagram: _ics.ivan Parts I Used: Junkyard Sway Bar Moog Sway Bar bushing Part #K8791 Moog Sway Bar Links Part #K80017
Жүктеу.....
Пікірлер: 52
@anthonyvazquez4033 жыл бұрын
One of the only obs Ford channels keep it going
@icsivan
3 жыл бұрын
Will do.
@jacksontheel48733 жыл бұрын
I subscribed immediately after you said you put the plastic battery holder in your pocket because I think everyone has taken small things from junk yards at least once
@icsivan
3 жыл бұрын
Hahaha, thank you for subscribing.
@miguelmoreno49772 жыл бұрын
Es justo el video que necesitaba, tengo una f150 del 95 que tampoco tiene las barras estabilizadoras y gracias a ti ahora se le pueden adaptar. Seria bueno que hicieras tu contenido tambien en español, nos seria de mucha ayuda a los que no sabemos mucho ingles. Gran video gracias.
@icsivan
2 жыл бұрын
Muchas gracias. Si, lo eh pensado, publicar videos en español. Ay cualquier pregunta me deja saber.
@omar_padilla3 жыл бұрын
Hey man great job but next time take us along for the test drive my boy.
@icsivan
3 жыл бұрын
Will do.
@carterforbes59953 жыл бұрын
Obs Ford trucks are amazing they will last forever my 5.8 sat in a field for five years and i put a new battery in it and it started right up
@icsivan
3 жыл бұрын
I bought mine for a guy that let it sit in a field too. Lol. When I came he said I’m not sure if it will start, and it did. Was a scary 40 mile drive back home though.
@wille8266
Жыл бұрын
Same. 6 years sitting in barn. New battery and fired right up. Tearing into it now. Bed off to get all the rear stuff including the SWAY BAR. Thx for vid. Subscribed
@jamesbarnett4166 Жыл бұрын
Damn LKQ here almost gives me stuff here
@derekgames17093 жыл бұрын
Yo bro my dad has a 96 F150 and you inspire me to start it as a project
@icsivan
3 жыл бұрын
That means a lot man. You won’t regret it.
@MacGregor. Жыл бұрын
Nice truck
@icsivan
11 ай бұрын
Thank you
@bernyestrada41333 жыл бұрын
That’s one clean obs! What’s your wheel and tire size?
@icsivan
3 жыл бұрын
235/75R15 in the front and 265/70R15 in the rear.
@MiguelMartinez-hm1hg3 жыл бұрын
Nice most have improvement if you dont have one especially on the front end I have a 1991 Ford Ranger and with out sway bar ones you hit 70 oh 75 that little thing felt like I was on a boat it was all over the place since I install one ot seats straight and no more swinging to the sides anymore if I hit 80 down hill 😅 no problem is more safe to drive
@jamesbarnett4166 Жыл бұрын
lightning links ?
@jerrettbrown18453 жыл бұрын
I went to the yard the other day finally found me a gauge cluster with a tachometer
@m2thaawesome6982 жыл бұрын
Okay, first off, your video already helped me by giving me the exact names of the parts im trying to replace. I do have one question...im changing the sway bar end links on my 1995 F-150, is there a certain amount of torque that you have to tighten it with? Or is hand tighten the way to go? And should you replace both end links if only one is broken? Thanks for posting this video!
@icsivan
2 жыл бұрын
There really isn’t any, usually torque depends on fastener size. What I do is tighten, with impact, until I see the bushings (rubber part) compress, (roughly 40-60 ft lbs.) and make sure none of the sleeves, washers are loose. Thank you for watching, glad I could help.
@m2thaawesome698
2 жыл бұрын
@@icsivan awesome thank you so much
@cynicustv2 жыл бұрын
What size bolt did you use to mount the rear sway bar links to the frame?
@cynicustv Жыл бұрын
Hey Ivan, What size bolt did you use to mount the rear sway bar links to the frame?
@icsivan
Жыл бұрын
Don’t remember, believe it was a 3/8 bolt
@raulangulo63513 жыл бұрын
Me and my dad are building a 1993 f250 fighter 5.8l v8
@icsivan
3 жыл бұрын
Nice.
@willwork2fish2613 жыл бұрын
Wheels? Those look good!!
@icsivan
3 жыл бұрын
They’re just some steel, staggered wheels I got off Craigslist.
@TheHbarreto2 жыл бұрын
Hola muy buenos tus videos una pregunta no pega los bar links de los lados cuando conduces la camioneta
@icsivan
2 жыл бұрын
Gracias, y no para nada.
@TheHbarreto
2 жыл бұрын
@@icsivan muchas gracias yo estoy en Florida y quiero hacer esto también
@TheHbarreto
2 жыл бұрын
Algo más de que camionetas tienes esa barra serán sólo las 4x4 solamente
@natalie827182 жыл бұрын
Does the rear axle hit the frame on bumps ? Thinking of getting mine c notched
@icsivan
2 жыл бұрын
Not even close, it has plenty of clearance, but I don’t know if it will if you C notch it.
@christyforbes64553 жыл бұрын
What size engine do you have
@icsivan
3 жыл бұрын
4.9 300, but not for long. 😎
@tonystokes87913 жыл бұрын
Are you sitting on the factory Shackels ? In the back.
@icsivan
3 жыл бұрын
Yes, I had lowering shackles but I didn’t want more than the 5” DJM offers
@tonystokes8791
3 жыл бұрын
@@icsivan I lowered mine but put a drop Shackel and now it’s to low in the back, I will have to reinstall the factory one back in and hopefully it will sit even.
@icsivan
3 жыл бұрын
@@tonystokes8791 Thats what i was afraid of.
@looney187-3 жыл бұрын
How much was the price on your 95 f150 when you first bought it ?
@icsivan
3 жыл бұрын
$1000.00
@sai_kyt3 жыл бұрын
Can I change from a regular f150 to a lightning?
@sai_kyt
3 жыл бұрын
I only mean from outside
@GerdauZach2 жыл бұрын
Did yours have a sway bar before?
@icsivan
2 жыл бұрын
No, it came from factory without one.
@franciscoanaya50633 жыл бұрын
What kind of coil springs are you running
@icsivan
3 жыл бұрын
Stock. DJM ,lowering kit Im running, recommends you run your OE coils, with no problem. Ride feels good
Пікірлер: 52
One of the only obs Ford channels keep it going
@icsivan
3 жыл бұрын
Will do.
I subscribed immediately after you said you put the plastic battery holder in your pocket because I think everyone has taken small things from junk yards at least once
@icsivan
3 жыл бұрын
Hahaha, thank you for subscribing.
Es justo el video que necesitaba, tengo una f150 del 95 que tampoco tiene las barras estabilizadoras y gracias a ti ahora se le pueden adaptar. Seria bueno que hicieras tu contenido tambien en español, nos seria de mucha ayuda a los que no sabemos mucho ingles. Gran video gracias.
@icsivan
2 жыл бұрын
Muchas gracias. Si, lo eh pensado, publicar videos en español. Ay cualquier pregunta me deja saber.
Hey man great job but next time take us along for the test drive my boy.
@icsivan
3 жыл бұрын
Will do.
Obs Ford trucks are amazing they will last forever my 5.8 sat in a field for five years and i put a new battery in it and it started right up
@icsivan
3 жыл бұрын
I bought mine for a guy that let it sit in a field too. Lol. When I came he said I’m not sure if it will start, and it did. Was a scary 40 mile drive back home though.
@wille8266
Жыл бұрын
Same. 6 years sitting in barn. New battery and fired right up. Tearing into it now. Bed off to get all the rear stuff including the SWAY BAR. Thx for vid. Subscribed
Damn LKQ here almost gives me stuff here
Yo bro my dad has a 96 F150 and you inspire me to start it as a project
@icsivan
3 жыл бұрын
That means a lot man. You won’t regret it.
Nice truck
@icsivan
11 ай бұрын
Thank you
That’s one clean obs! What’s your wheel and tire size?
@icsivan
3 жыл бұрын
235/75R15 in the front and 265/70R15 in the rear.
Nice most have improvement if you dont have one especially on the front end I have a 1991 Ford Ranger and with out sway bar ones you hit 70 oh 75 that little thing felt like I was on a boat it was all over the place since I install one ot seats straight and no more swinging to the sides anymore if I hit 80 down hill 😅 no problem is more safe to drive
lightning links ?
I went to the yard the other day finally found me a gauge cluster with a tachometer
Okay, first off, your video already helped me by giving me the exact names of the parts im trying to replace. I do have one question...im changing the sway bar end links on my 1995 F-150, is there a certain amount of torque that you have to tighten it with? Or is hand tighten the way to go? And should you replace both end links if only one is broken? Thanks for posting this video!
@icsivan
2 жыл бұрын
There really isn’t any, usually torque depends on fastener size. What I do is tighten, with impact, until I see the bushings (rubber part) compress, (roughly 40-60 ft lbs.) and make sure none of the sleeves, washers are loose. Thank you for watching, glad I could help.
@m2thaawesome698
2 жыл бұрын
@@icsivan awesome thank you so much
What size bolt did you use to mount the rear sway bar links to the frame?
Hey Ivan, What size bolt did you use to mount the rear sway bar links to the frame?
@icsivan
Жыл бұрын
Don’t remember, believe it was a 3/8 bolt
Me and my dad are building a 1993 f250 fighter 5.8l v8
@icsivan
3 жыл бұрын
Nice.
Wheels? Those look good!!
@icsivan
3 жыл бұрын
They’re just some steel, staggered wheels I got off Craigslist.
Hola muy buenos tus videos una pregunta no pega los bar links de los lados cuando conduces la camioneta
@icsivan
2 жыл бұрын
Gracias, y no para nada.
@TheHbarreto
2 жыл бұрын
@@icsivan muchas gracias yo estoy en Florida y quiero hacer esto también
@TheHbarreto
2 жыл бұрын
Algo más de que camionetas tienes esa barra serán sólo las 4x4 solamente
Does the rear axle hit the frame on bumps ? Thinking of getting mine c notched
@icsivan
2 жыл бұрын
Not even close, it has plenty of clearance, but I don’t know if it will if you C notch it.
What size engine do you have
@icsivan
3 жыл бұрын
4.9 300, but not for long. 😎
Are you sitting on the factory Shackels ? In the back.
@icsivan
3 жыл бұрын
Yes, I had lowering shackles but I didn’t want more than the 5” DJM offers
@tonystokes8791
3 жыл бұрын
@@icsivan I lowered mine but put a drop Shackel and now it’s to low in the back, I will have to reinstall the factory one back in and hopefully it will sit even.
@icsivan
3 жыл бұрын
@@tonystokes8791 Thats what i was afraid of.
How much was the price on your 95 f150 when you first bought it ?
@icsivan
3 жыл бұрын
$1000.00
Can I change from a regular f150 to a lightning?
@sai_kyt
3 жыл бұрын
I only mean from outside
Did yours have a sway bar before?
@icsivan
2 жыл бұрын
No, it came from factory without one.
What kind of coil springs are you running
@icsivan
3 жыл бұрын
Stock. DJM ,lowering kit Im running, recommends you run your OE coils, with no problem. Ride feels good
@franciscoanaya5063
3 жыл бұрын
Are you running moog?