A lovely kit, with only one flaw. It was a pleasure to build, the fit was great, but the wings could be moulded better. Not a major issue though and it didn't put me off.
Жүктеу.....
Пікірлер: 9
@PeterPie13223 күн бұрын
Lovely model Barry. Can't wait to make a start on mine!
@RichardsModellingAdventures20 күн бұрын
I'm just getting near the end of building one of these. These cylinders are bugger to do. Not a bad kit
@stevemercer9526 күн бұрын
Another great video and a very nice looking kit!
@nostalgicplastic4323
6 күн бұрын
@stevemercer952 cheers Steve!
@stevesstuff145023 күн бұрын
That looks lovely! You did a really good job with what looks a great - if fiddly - kit! 👍👍
@nostalgicplastic4323
23 күн бұрын
@@stevesstuff1450 cheers Steve!
@johnhughes265324 күн бұрын
I'm wondering if the wings have distorted after coming out of the mould. The outer surface is slightly larger than the inner surface and therefore shrinks more, which tends to flatten the profile of the wing?
@nostalgicplastic4323
23 күн бұрын
@johnhughes2653 not sure. Just looks wrong. If I'd noticed I'd have tried sanding but I'm not too worried. It was a nice one, I did your wire idea, but I chose some that was a bit bendy. Next time....
@BradleyHatchen-vv3fd19 күн бұрын
This build took way to long ki.nd of a slow build I went else where it was too long got tired and left
Пікірлер: 9
Lovely model Barry. Can't wait to make a start on mine!
I'm just getting near the end of building one of these. These cylinders are bugger to do. Not a bad kit
Another great video and a very nice looking kit!
@nostalgicplastic4323
6 күн бұрын
@stevemercer952 cheers Steve!
That looks lovely! You did a really good job with what looks a great - if fiddly - kit! 👍👍
@nostalgicplastic4323
23 күн бұрын
@@stevesstuff1450 cheers Steve!
I'm wondering if the wings have distorted after coming out of the mould. The outer surface is slightly larger than the inner surface and therefore shrinks more, which tends to flatten the profile of the wing?
@nostalgicplastic4323
23 күн бұрын
@johnhughes2653 not sure. Just looks wrong. If I'd noticed I'd have tried sanding but I'm not too worried. It was a nice one, I did your wire idea, but I chose some that was a bit bendy. Next time....
This build took way to long ki.nd of a slow build I went else where it was too long got tired and left