How to adjust the needle as part of the rejetting process by Jets R Us.
Жүктеу.....
Пікірлер: 20
@itsMrBRoc
I didn't know how to do this and you tell how and get to the point! So thank you!
@twineofdeath337 жыл бұрын
Thank you very much for the video! I was puzzled why my bike was bogging out at full throttle and this totally solved the problem.
@uvkvk7 жыл бұрын
Hello
@p.c.h.67215 жыл бұрын
Question. If I put the needle in the highest possible position (number 5 on my carburetor) and I find that the throttle is still not responding that well, then does that mean that I need a bigger main jet? Thanks in advance.
@mattymurray81282 жыл бұрын
My needle keeps breaking after about 2 hours of run time ? Any suggestions?
@kiran-wh9wg7 жыл бұрын
i had a bent needle i replaced it which was very very slightly thicker than the old but it was of exactly same length do you think it wil cause any effect
@dailylifefishing52215 жыл бұрын
Where to put the clip to make my motorcycle fuel consumption reduced? to the top? or to the buttom? i need answer. thanks
@jerrybigrig94752 жыл бұрын
Do you have a video on this engine is running lean..with that engine running poorly..you adjust this needle ..like here ..go back to video..this is how much better it now runs ..???
@tonkoljanos31953 жыл бұрын
Can you adjust between the clips?
@patrickkmanning4 жыл бұрын
What do you do, if there is only one notch? Can that be adjusted? I need to adjust the idle.
@imgaiy35885 жыл бұрын
My bike sputter and pops when it’s all warmed up, should I bring the clip up or down
@violeman9 жыл бұрын
Where was the spring clip to hold the needle down?
Пікірлер: 20
I didn't know how to do this and you tell how and get to the point! So thank you!
Thank you very much for the video! I was puzzled why my bike was bogging out at full throttle and this totally solved the problem.
Hello
Question. If I put the needle in the highest possible position (number 5 on my carburetor) and I find that the throttle is still not responding that well, then does that mean that I need a bigger main jet? Thanks in advance.
My needle keeps breaking after about 2 hours of run time ? Any suggestions?
i had a bent needle i replaced it which was very very slightly thicker than the old but it was of exactly same length do you think it wil cause any effect
Where to put the clip to make my motorcycle fuel consumption reduced? to the top? or to the buttom? i need answer. thanks
Do you have a video on this engine is running lean..with that engine running poorly..you adjust this needle ..like here ..go back to video..this is how much better it now runs ..???
Can you adjust between the clips?
What do you do, if there is only one notch? Can that be adjusted? I need to adjust the idle.
My bike sputter and pops when it’s all warmed up, should I bring the clip up or down
Where was the spring clip to hold the needle down?