yo this is wild, so dope man. just found the best n54 channel out there. damn

32 psi wow! id definitely be putting in forged rods & pistons at those power levels

@941garage

2 жыл бұрын

Stock motor did really good tbh, but the damn bolt just backed out.

2:39 now it looks like a G87 M2 grille.

How much for the intake cam trays?

Hey man, when you installed your oil cooler, did you fill it with some oil before you started the car?

@941garage

Жыл бұрын

No I didn’t, I just primed the car a few times before the initial start.

I’m sure you know but make sure to replace oil cooler with the new engine.

@941garage

2 жыл бұрын

🤔, never heard of this. Why so?

@TavenPutnins

2 жыл бұрын

@@941garage it’s a common thing to do if your motor goes because there can be metal shavings that run through it and you want to avoid that running through a new engine. I picked up on it from a few KZreadrs building engines, specifically devin niemela and others as well.

@941garage

2 жыл бұрын

@@TavenPutnins oh ok, I see what you mean. In my case I don’t need to because the only thing that happened was the valves got bent and the chain broke. There were no metal shavings at the bottom of the pan or oil filter. I’ll probably just flush it out just to be sure. Thanks

@e92erik

2 жыл бұрын

@@TavenPutnins everything he touches blows up☠️ but definitely change that oil cooler

What’s up man, just wanted to know if you still have that Jackspania Shifter set up? I just ordered mine and wanted to know how you like it

@941garage

Жыл бұрын

Yah I still got, its ok for the money but definitely not the best. If you get it I’ll recommend you to disassemble it and put locktite on all the hardware. And also use light grease in some areas.

@SoldierMateus

Жыл бұрын

Alright will do. Thanks for the heads up man.

Hey man could I get the link or the sizing of your cold side charge pipe

@941garage

Жыл бұрын

Which pipe are you talking about? The one after the charge pipe?

Yikes 😬