You edited the part where you took it apart! Wanted to see the magnets and how they were sitting! LOL

@PenguinOutdoors

3 ай бұрын

SD card corruption, unfortunately. Had to edit around what I had.

Thanks for the video, can you direct me to where you got your replacement parts?

@PenguinOutdoors

2 ай бұрын

Trollingmotorparts.com!

how did the cleanup and repair go?

@PenguinOutdoors

4 ай бұрын

Perfect! She is running like a champ. I have another video for that on here :)

@MattClapss

4 ай бұрын

@@PenguinOutdoors I’m having the same issue, can you link me the video?

@PenguinOutdoors

4 ай бұрын

@@MattClapss The other video I made was just a short showing it clean and running. I cleaned up the internals, replaced the seals and put it back together.

@rhaney7583

2 ай бұрын

@@PenguinOutdoors hey im having the same issue but with salt water so its much worse. Where do the new seals go? are there any around the shaft which drives the prop. Thanks

@PenguinOutdoors

2 ай бұрын

@@rhaney7583 you should verify my answer in a parts diagram since yours is salt water, as it might be different from mine. Because salt is highly corrosive I’d assume the salt water version has more or different seals that may be placed differently. On mine the seals were, to the best of my recollection: one on the end cap, one on the cap on the prop side, and on each of the long bolts that go in and hold it all together.

I pulled mine apart trying to get the blades to spin the right way. Now it does not want to go back together. Cant get both ends on flush. Did you have any issues putting it back together?

@PenguinOutdoors

23 күн бұрын

I did not, but it all has to mesh together correctly or it won’t seat. Make sure the armature is in the correct direction and make sure the pass through bolts are going through their designated area of the case. Check why make sure you don’t have an old o-ring left on in addition to the new one. Make sure it’s all clean.

@5eFarms

23 күн бұрын

@@PenguinOutdoors ill check that out. Thank you