Thanks so much for this video! It’s very useful.

The extended section for DCmotors doesn't show up for me and I can't find the PIDF blocks either.

thanks for this really helped

Hi, how can I program it to rotate to certain point then it stops again?

My motor just gives off a high pitched noise but doesn’t move

please could you help me, I try the same code in RUN_TO_POSITION and it not working the tablet show erro that I can't use RUN_TO_POSITION mode before I set Target position, and when I do that the error still apear or in another case ,it run but motor just rotate without stop

@WizardsexeFTC9794

4 жыл бұрын

Do you have the encoder cables plugged in? Test if the encoder is working, as some teams have been having problems with the HD Hex motors in the 2019 FIRST Global kit. FIRST Global Team UK has a video released on how to fix the encoder problem. If you still can't figure it out, email us at wizards.exe@gmail.com so we can help you more.

@NovaArc

4 жыл бұрын

@@WizardsexeFTC9794 thank you very much ❤ I see the video of UK team and I think we have the same problem

Hello There! My team is facing a problem where Dc Motors does not show up under actuators. We have tried many things, including using different motors and switching cables, to no avail. I could not find anything online for this, so I was wondering if you would have any guidance on this

@yoncesulita7873

Жыл бұрын

Did you guys remember to configure the motors in your Driver Hub?