Mitsubishi Lancer 2003 ES - Valve Cover Gasket Replacement
Автокөліктер мен көлік құралдары
A valve cover gaskets is made of plastic, rubber, or cork which is used as a seal between the engine block and the head cover.
There is no maintenance on valve cover gasket but is usually replaced when there is an oil leak.
Symptoms of bad valve cover gasket:
⦁ Oil leaks from the engine
⦁ Low oil level
⦁ Burn smell
⦁ Smoke from engine compartment
Torque Spec
⦁ Ignition Coil bolts: 89 ± 17 in-lb (10 ± 2 N⋅m)
⦁ Valve Cover bolts: 27 ± 4 in-lb (3 ± .5 N·m)
⦁ Throttle Cable Clip bolt: 89 ± 17 in-lb (10 ± 2 N⋅m)
Пікірлер: 21
I know your a professional cus this the first video I seen WITH RTV seal. It will make the gasket last longer
Nice Kong! You sould make a calibration valves video, It could be very insteresting Cheers and keep uploading great infor videos!
@donkeykongchang
2 жыл бұрын
Thanks for the idea!
Good job, do you know how to adjust the valves clearance?
Can you send a link where I can download repair manual for lancer. I like the info you are giving
I'm wondering where has your channel been hiding, 🤔
Question have you ever had a problem if oil goes through the rubber seals for spark plugs
Where do you get the new gasket from
@juanjrodriguezdiaz225
11 ай бұрын
Autozone,Oreillys,Amazon
How do u get the dirt and oil out of the inside of the spark plugs tube????😭😭😭😭
@Mr_Chipp
2 ай бұрын
I use a air compressor but if you don't have one use a can of brake kleen and a paper towel
Did you use a 1/4 or 3/8 torque wrench?
@miguelsalas1916
Жыл бұрын
1/4
Wait a bit for rtv to tack up before the cover goes on.
You don't need silicone!!!!!!!!!!!!!!!!!!!
@krakenbodyboarding365
Жыл бұрын
Le puso demasiada
@joemcshmoe10
Жыл бұрын
I was wondering this. I read the silicone isn’t needed. This true? Just smack the gasket on and good to go?
@kgpcodes
7 ай бұрын
It depends on the condition of the metal. Mechanics use RTV just to be safe.
@sectokia1909
7 ай бұрын
@@joemcshmoe10 If both surfaces are smooth all the way around, you don't need anything. If there are cuts/dents/scratches, then you will have to use it to fill them in. If this is the first time ever opening it and you are careful not to damage surfaces, you shouldn't need anything except the gasket.
@white6942
4 ай бұрын
Why you don't need to use silicone?, Whhhhhyyyy!!!!!
11:31 the directions said to do what ??