Mitsubishi Evo "SD" Conversion! How To Wire In GM IAT & 3Bar MAP Sensor 4 5 6 7 8 9 MAF Delete Video
Ойын-сауық
Full How To Video.
Mitsubishi Evo 4-9 "SD" Conversion!
In This Video I show You How To Wire In:
GM IAT (Intake Air Temp) Sensor
&
GM 3Bar MAP Sensor.
Full Video From Start To Finish.
If You Found This Video Helpful Then Please "SUBSCRIBE" To My Channel!
Please Hit That "Thumbs Up" Button!
And Share My Videos With Your Friends.
Check Out My Other Current Builds and Other Videos.
:).
Many Thanks For Watching.
Thank You.
:).
Пікірлер: 10
Great Instructional Video.
Thank you this vid was very helpful as to where I wire into.
@MontaniRacing
18 күн бұрын
@@doggodog838 I am glad it helped you. Only one thing to note, depending on which map sensor you use, my mapper had to invert the map signal in the map. But this setup works well. The car is quick! Have you watched my dyno video on my channel? And also the video of me taking the car for a run?
Watch until the end....
Good work. Get that rattle can out tho!! 😅
@MontaniRacing
6 ай бұрын
🤷🏽♂️
How did u install d engine mounts
@MontaniRacing
2 ай бұрын
I made new chassis mounts. 👍🏽
Did you used sd mode to tuned afterthat?
@MontaniRacing
3 ай бұрын
Yes.