That little power feed has made life so much easier Ad. Also fun to build. Thanks for looking Cheers Nobby

Thank you Jon. Your comment is welcome and much appreciated. Cheers Nobby

Very interesting Nobby. A good solution. Cheers Rob

@nobbysworkshop

8 ай бұрын

Thanks Rob. Any sign of you getting a mill some day? Cheers Nobby

@Xynudu

8 ай бұрын

Hi Nobby, I keep looking, but they are either too big or too small for what I want it to do. I get by milling on the lathe and it works quite well for most things. Also space to put one is the issue. I don't really want to get rid of my old Taiwanese 12 speed pillar drill, but that's about the only place a mill could go. No rush. Cheers Rob@@nobbysworkshop

Gday Nobby, good simple setup mate, great job, cheers

@nobbysworkshop

8 ай бұрын

Thanks Matty a much appreciated comment. Thank you for watching. All the best mate. Cheers Nobby

Powerfeed is the dream for mini mill owners. The less power, the more power feed is needed for sweet finishes. The mini lathes help to get a great finish with longitudinal feed(crossfeed is in heaven), the mill would be the same👍👌🇦🇺(🤞 for a 1K Christmas 😊)

Well done Nobby, simple and effective solution. Something that's on my ever growing to do list for my mill. Cheers, Jon

Nice work

@nobbysworkshop

8 ай бұрын

Thanks Rusty much appreciated Cheers Nobby

Nice intro - through the keyhole

@nobbysworkshop

8 ай бұрын

Exactly, the lights were on, but no-one at home. Cheers Nobby

Hi Nobby. Title says Cross feed, but it is table X feed😊 Regards from Australia

@nobbysworkshop

8 ай бұрын

My IT department has corrected the title, and sent me to the corner with the Dunce's Hat. Cheers Nobby

Hi Nobby. I used a stepper motor and stepper controller and a 24 volt psu my motor is Fited in Place off the Handel. Form Brian

@nobbysworkshop

8 ай бұрын

Hi Brian this is surely the best way to do it, but at the time I had some constraints on costs. As my mill is so small the little geared motor worked out fine. Thanks for looking. Cheers Nobby