Was this the first time running it? Tons of room for improvement.

very good😊

So you use a 5 axis mill so it can clean the pallet off after your done machining the parts?

@wrighty338

22 күн бұрын

i got to the end and realised too 😂

was this programmed in PowerMill..?

@CVF_RACING

25 күн бұрын

TopSolid

Yea I'm hammering those out in under 10 minutes on a machine that costs 1/2 as much.

your machine needs a clean....

@CVF_RACING

18 күн бұрын

Agreed!

No offense to whoever programmed this, but to have this terribly optimized program running in a robotic cell seems almost criminal. I could make those parts in conservatively, 40% of the time

@wrighty338

22 күн бұрын

I see this often on here and im not even a professional programmer or machinist. There's some process optimisation to be had here i think.

@mjshorty19

22 күн бұрын

@@wrighty338 being a programmer for the last 7 years and only being 29 years old, I'm aware I don't know even close to everything about machining. But I tend to think I know what I am doing relatively well and I would never in my wildest dreams put a program like this out into our shop to run a production part

@CVF_RACING

18 күн бұрын

This video is for customers that have asked to see machined parts in action. To eliminate coolant spray from getting on the camera, sacrifices in speed and efficiency need to be made. We are not trying to show off here 😁