Metal Casting (Part 3: Designing the Gating System)
This video discusses the thought process behind the design of the gating system. The gating system of a casting mold is essentially a fluid dynamic system and adheres to the same principles of fluid mechanics such as Bernoulli's Theorem.
Facebook: / infinitymfg
Twitter: ?lang=en
Пікірлер: 27
Excellent lecture. Great job!! Your explanations of casting processes makes it easy to grasp the concept.
wonderful lecture cleared all my doubts...… Thank you sir!!!
Thank you for this video, very good job, very clear, very useful not only for students...
Great content!
Pretty good as far as an introduction. Careful though, for pipe flow fully laminar flow is Re
@AJ-sb8qk
2 жыл бұрын
Seems to me that the only purpose of your comment was to highlight the fact that you feel as though you know a little something about casting. That was very arrogant to say " pretty good as far as an INTRODUCTION" how about just saying that the lecture was pretty good. Everyone who viewed the video learned something. I was glad the professor didn't respond to your comment. Next time, before you speak tell your mouth to behave like a typical casting defect and.... COLD SHUT
Hello, thanks for the educational presentation. Could you tell me the literature source please from which you took the schematic figure of the casting system used @5:41 ? Thank you very much in advance.
Professor Which density to consider , when it is a molten metal or solidified.For Reynolds number
Muchas gracias por el video
Sir, can you also explain in what time we can fill the mold and the logic behind it's calculations ?
Re number for laminar flow is 2300, above that is transition zone and turbulent flow :) , great video thanks
@infinitymfg5397
7 жыл бұрын
Thanks for watching! I appreciated it!
@evanhansen2443
6 жыл бұрын
great lectures. thanks!
Thank you sir
Wow! Sir you are great at this. Nice lecture. Thank you.
@infinitymfg5397
4 жыл бұрын
Thanks for your feedback!
Any chance you would do a part 4 metal casting on design considerations? Such as limitations on geometry of parts and on the process itself?
@infinitymfg5397
3 жыл бұрын
I may have to add a part 4 the the playlist.
@NaF_Art_Studio
2 жыл бұрын
@@infinitymfg5397 ouh please do sir. great content thanks for the efforts.
What is gating system for copper??
Not sure if you still check this or not but with regards to the gating system are there limitations to designing around the parting line of die halves for part extraction?
@infinitymfg5397
3 жыл бұрын
Hello! Yes the position of the parting line is dictated by the density of the material that you care casting.
tq sir
❤
Sin-o di taga TUPV? comment kamo😅
Sir aap video thodha hindi me bhi kro