Meshtastic Heltec v3 Hardware Build

Тәжірибелік нұсқаулар және стиль

I talk through the experience and the lessons learned on build a meshtastic node. To come soon: Meshtastic Heltec v3 Flash and Configuration.
Amazon Affiliate Links:
Antenna 2 Pack: amzn.to/44VKD1D
Heltec V3 2 Pack: amzn.to/4bJKPTK
GPS Module 2 pack: amzn.to/3UREzCS
Battery 4 pack: amzn.to/3UVYVdU
Switches: amzn.to/4az5RUm
M3 Bolts & Nuts set: amzn.to/4bFEgBQ
30 AWG wire I used: amzn.to/4bNHHXg
3D Models print yourself or use the links in the description here to find out where you can purchase for yourself: www.printables.com/model/5613...

Пікірлер: 7

  • @powray
    @powrayАй бұрын

    This is great for people with drones in areas not flat enough to send msgs long distances

  • @sorinpopa
    @sorinpopa26 күн бұрын

    I printed the tall version of the buttons, scaled down 0.2mm on the Z axis, and for me it was a perfect fit, not popping out much, definitely no accidental push possible. Printed in BambuLab PLA basic. For the switch I used two M2 screws, and it holds it very well.

  • @KH07734
    @KH07734Ай бұрын

    I have yet to find the pinouts for the 820 barometric pressure board. Do you have any links?

  • @TheBrokeHam

    @TheBrokeHam

    Ай бұрын

    I'm not familiar with that board. A quick good Google isn't turning up any results. Where did you get the board from?

  • @KH07734
    @KH07734Ай бұрын

    I use the same batteries but the charger I use does not charge them. Using Solar causes the battery to drain fast when the sun goes down.

  • @TheBrokeHam

    @TheBrokeHam

    Ай бұрын

    Are you only using a solar charger? I'm using a regular wall charger and it charges. It sounds like something might be wrong with that solar panel like it's missing a diode

  • @brianpacchetti5028

    @brianpacchetti5028

    Ай бұрын

    Put couple of diodes in line with solar panel charging leads so current flows one direction.

Келесі