Yaser and the crew at VEProfessionals definitely know their stuff. Sent my 2006 CLS55 AMG key and EIS to them because my FOB would not turn the ignition to accessory 1 or 2 so I couldn't tune the vehicle after some mods. Yaser and crew found that the EIS was fine, but the key was bad. They were able to program a generic key to do everything I needed, and sent both keys and EIS back. All in all it took me two (2) weeks and it works great. If you have issues with either your EIS or FOB/Key, Yaser and his crew are the people to send it to.

nice and informative video😇

Good explain thanks.

Very informative

Recently had this eis issue on my 2004 clk 55 amg wish I would’ve seen this video sooner

Hello make thanks again sir. What does "HO" mean and why didn't it change on the new unit? I've seen other videos that said should say yes or check also.

Interesting video, thanks for explaining some possibilities associated with a no-start no turn of the key, no dash lights situation. How did you figure out what’s wrong exactly and how do you fix it?

Is there a reference guide for which frequency is needed for what class of mb a person is working on ? 315 or 433 MHz

do you have blank (virgin) key fob? I am looking for 216 (CL500)?

My 2009 mercedes benz c350 when you get the key in the ignición switch the esl unlock but when you turn the key the dash board does goes on, this still the esl has a malfuntion?

Hello. On my 09 GL450. Trying to start the car the starter relay fuse blows.

Please any ideas of what could be the problem with my c350 w204 ignition on light comes on the dashboard but no cranking but if you crank from the front Sam relay the engine started I go on diagnose I got B169213 and it says output circuit 58d has malfunction,there’s an open circuit but couldn’t see the wires having issue

OK I HAVE A QUESTIONS? I OWN A 2004 MERCEDES CLK500 WITH THE KEYLESS GO AND KEYLESS START. I ALSO OWN A 2005 CLK 55 AMG CABRIOLET , WICH I WOULD LIKE TO ADD THE KEYLESS GO AND KEYLESS ENTRY. WHAT ITEMS WOULD I HAVE TO REMOVE FROM THE 2004 AND INSTALL IN THE 2005? CAUSE SOME PEOPLE SAY THE CLUSTER HAS TO B REMOVED ALSO. IF U HAVE ANY INFO IT WOULD GLADLY B APPRICIATED! THANKS UR VIDEOS GIVE LOTS OF GOOD INFO.

How is the situation if i put the key in, sometimes it unlock immediately, sometimes i need to wait for few seconds, sometimes no response i need to try couple times, then is it the key the els or eis？

thanks for the info, I'm wrong p2071 das doesn't send engine start request, eis works without problem with other key, but the new key programmed by Mercedes Benz doesn't work, it says computing data please wait. could it be the ecu causing the problem because it does not send the engine start request. please answer my question

Could a bad alternator also cause a no start? aux battery and main battery are new both about 3 months. I replaced them because it wouldn’t start it started up when I replaced the aux battery for about a week then no start again. Key is responsive and dashboard lights up but no response when key is inserted and steering snd is not locked. Any ideas?? Bad key, EIS, alternator? Thanks

Please how do I get help? My C300 Mercedes is currently having this problem. Sometimes it starts but sometimes it doesn't. I'm in Nigeria.

Very informative, thank you. So you cant diagnose what unit is faulty with any obd tester or multimeter? You need special tools. The motorola chip in older key is the common failure point, right? Then if esl motor sounds weak its likely going to fail. If both working keys fail same time eis could be the problem. I have two old keys and cant figure out what should I repair, Both keys have worked intermittently. I guess I should start with making new key cause it's good to have anyway.

I sent you an email regarding my 2008 c63 amg. Ty

50 signal without CAN will cause crank but no start?

Is there anyway of testing them without removing anything pretty much just thru obd

@VEPROFESSIONALS

2 жыл бұрын

Best on bench to eliminate other variables

i had a poor connection to steering lock no start vito

Shout out to the camera man. Are you stationed in the us?

@VEPROFESSIONALS

2 жыл бұрын

Now he wants a raise 🤣. We are based in Hamilton, Ontario Canada.

Hie, do you offer online lessons?

Question - 2005 Kompressor. Battery died and key would not turn, replaced battery and key now turns, steering wheel unlocks, lights on the dash, radio works, etc.. but car does not start. No signal to the relay. In the video, it says you can turn the key on an older car, everything should be fine with the ESL and EIS. Is there ever a situation where it would turn, everything working except for the ability to start? Is this something you guys can fix?

@VEPROFESSIONALS

Жыл бұрын

Email info@vepro.ca for specific case inquiries

Good morning I have a 2010 GL450 when I connect to the vehicle with the scanner, I get a Key in Position HO auxiliary contact NO, also steering wheel is unlocked, but I don’t hear the ESL work at any time. Any suggestions? I appreciate your feedback. Thanks again.

@VEPROFESSIONALS

6 ай бұрын

Best to reach out to info@vepro.ca Thanks for watching!

Can you repair fbs4 w212 ESL , sometimes works but sometimes doesn’t work , when it doesn’t work the steering lock is dead, nothing happens when I turn the key ?

@sabanoureen6898

5 ай бұрын

how did you solve it? same issue

@ImranAli-rp4kd

5 ай бұрын

@@sabanoureen6898 I replaced the motor inside the electronic steering lock

Do yall have contact info so I can send in my stuff to be fixed

could you please give me the links for the products and software so that I can make a test bench. I am venturing into the used car market and I'm running into this problem with a lot of Mercedes.

@VEPROFESSIONALS

2 жыл бұрын

www.vepro.ca Email info@vepro.ca for further inquiries

I purchased one of your emulators yesterday. Today, after several hundred attempts to get my 1999 CLK430 W208 steering lock to disengage, it finally worked! I immediately removed the battery cable and disconnected the wiring from the ESL. Since it is unlocked and disconnected, is there any reason to remove it before installing the emulator?

@ScottAles

8 ай бұрын

Sadly, I finally got back to my car months later, installed your device, got the red light instead of green. Oh well...😔

i Have a W207 that has been disabled key positions. cannot enable. has error code failed to enable key. Help please

@VEPROFESSIONALS

2 жыл бұрын

Email info@vepro.ca

Hy that's an amazing awesome video thank you very very much I'll be learning and watching your video with all my heart. 1 questions u saying if u get that little black bypass and plug it like you did u wouldn't need the Old stering lock device? Last this it well be nice to see how you program it.

@VEPROFESSIONALS

2 жыл бұрын

More details related to plug and play bypass emulators vepro.ca/product/mb-universal-emulator-steering-lock-emulator-for-usa-canada-sprinter-crafter-w169-w245-w202-w203-w208-w209-w210-w211-w639-w906/

@dashtyATG

Жыл бұрын

I been texting you guy's on WhatsApp FB so on. but I'm surprised you never replying if no what's a point keep westing your time making videos hear

My key want turn or my eis isn't recognize it can someone help me is it the key or what🥺

@VEPROFESSIONALS

2 жыл бұрын

Email info@vepro.ca

ALSO WHERE CAN I GET PRICING ON UR ITEMS? THAKSK

@VEPROFESSIONALS

2 жыл бұрын

www.vepro.ca or email info@vepro.ca

hi there. i have problem with EIS and i was trying to take out and also to take out the ESL, the SURPRISE: no ESL on my car. in place of the ESL or emulator is just an sponge and there is no blue plug for ESL. how is this possible? now i need to syncronise only new EIS and old keys to car? no more ESL? please give me some info that can take me out from fog. Best regards, Ovidiu.

@VEPROFESSIONALS

Жыл бұрын

Some vehicles are not equipped with ESL by default. Contact info@vepro.ca to discuss further. Thanks for your support!

@djovidius3545

Жыл бұрын

@@VEPROFESSIONALS contacted. Thank you.

How much you charge if i send mine in to be fixed ?

@VEPROFESSIONALS

3 ай бұрын

Please contact info@vepro.ca to discuss details

What are you prices roughly

@VEPROFESSIONALS

2 жыл бұрын

www.vepro.ca

These cars are crap !

@jeanlevy374

Жыл бұрын

Hello Sir I'm happy to join you, I got a problem that you can help me with, my 2005 Mercedes Benz c320 has an ignition module how can you help me out please.

Hi sir i message you on facebook i hope to hear from you soon, thanks