Mercedes Benz 320 M112 V6 Engine Maintenance / Valve Covers & Breather Hoses
Автокөліктер мен көлік құралдары
Today we give a breakdown on some preventative maintenance on the M112 SOHC V6. We changed the valve gasket covers, breather covers/hose and cleaned up the engine bay.
Supplies/Parts purchased from FCP Euro!
Feel free to reach out with questions you may have, thanks for watching.
The torque spec for this M112 engine is 71 inch pounds (8 Nm) on the valve cover bolts. If you end up working on the M113 engine [V8], you will want to torque them down to 7 foot pounds (10 Nm).
Пікірлер: 12
Master please how ....in which degree will I turn the engine to it timing
Does this Engine have a slot where I can install distributor if I want to?
Did you use genuine mercedes gaskets? I bought L & R felpro gaskets but I hear genuine is the way to go . I have a 04 e320 base.
@apexvisiontv
4 жыл бұрын
Hello. Yes i did. I ordered gaskets from FCP Euro. I ended up going back over all the bolts with a torque wrench because i was getting a small leak on my passenger side.
@andregenter4213
2 жыл бұрын
M5x16 bolts on small covers have to be replaced. 4NM on them and 7NM on the ones of the bigger cover. ALWAYS use a torque wrench according to the instruction papers from Mercedes…
What about this engine turbocharged?
@apexvisiontv
4 жыл бұрын
Nah it’s Naturally Aspirated. Thanks for commenting.
@KurruptedDataYouT
4 жыл бұрын
@@apexvisiontv Yes, I know its N/A. I mean can it handle a turbocharger?
@apexvisiontv
4 жыл бұрын
Kurrupted Data honestly doubt they make something for it. Would need to be custom. Probably easier to v8 swap
@KurruptedDataYouT
4 жыл бұрын
@@apexvisiontv I want a w210 wagon and I thought a ls 4.8 swap would be difficult due to the wiring.
@apexvisiontv
4 жыл бұрын
Kurrupted Data depending on your power goals I would just look into getting the e500 v8.
where is your video on how the replace those hard breather hoses?/ Without that you video doesn't have much value.