How did you measure out the placement ? Do you have any guides on that ? br Last
@1968ferg
7 жыл бұрын
The top of the tunnel should be 185mm below the waterline and as far forward in the bow as you can get it.
@jameshoward78453 жыл бұрын
What size PVC pipe does that require?
@1968ferg
3 жыл бұрын
It's a 125mm fiberglass tube, I'm not sure you could use PVC as it would be harder to fiberglass inplace.
@maliquepatterson722 жыл бұрын
Easy
@overlanderengel57873 жыл бұрын
Propeller does not seem to be well balanced
@1968ferg
3 жыл бұрын
4 years later and no problems with it, there is a rubber gasket between the motor and the tube so I would expect a small bit of movement as it's quite a powerful motor.
Пікірлер: 13
Lovely work Fergal!
Measure twice cut once good job well done !
Some job. Hope you're on the mend
Arses would fit a system on this
How did you measure out the placement ? Do you have any guides on that ? br Last
@1968ferg
7 жыл бұрын
The top of the tunnel should be 185mm below the waterline and as far forward in the bow as you can get it.
What size PVC pipe does that require?
@1968ferg
3 жыл бұрын
It's a 125mm fiberglass tube, I'm not sure you could use PVC as it would be harder to fiberglass inplace.
Easy
Propeller does not seem to be well balanced
@1968ferg
3 жыл бұрын
4 years later and no problems with it, there is a rubber gasket between the motor and the tube so I would expect a small bit of movement as it's quite a powerful motor.
@overlanderengel5787
3 жыл бұрын
@@1968ferg cool .