I use the same software on a Titan 2 cutter. Calibrate your cutter and your contour cutting will be spot on for every single sticker.

Thanks for the great video what is the price for the vinyl cutter.

What kind of paper did you use to print?

No laser detection for registration mark ?

Just to be clear… the Vevor cutter also does full color print? Also, do you print on a laminated vinyl? Or do you print… laminate … and then put laminated vinyl back into the vevor to cut?

Hi. I have the vevor plotter for about 7 years now. Trying to do die cut manually but alignment keeps running and simple cuts always have issues.

I tried to cut mylar on my Vevor, It cut but I think I need a mat board to hold it in place!! Have you tried cutting thicker material? I was trying to make a template 😊Robbie

Is 34 size the sweet spot? Since they are smaller ones. I’m looking to do big cuts I have a Cricut explore air 2 and to do a big sticker I have to do some many cuts

How long you have this cutter?

Hey man, I'm trying to cut my decals on printable vinyl after applying a UV laminate over after printing, but I just can't get it to cut through at all and I'm on the high pound for cut. Any suggestions?

software said 1 inches below... question is below the square mark or below the cross???

From my experience, I believe you have to use the offsets feature in the software rather than going into the manual move mode.

need help pleaseeeeeeeee

I'd say check the software on the tools tab. I had a funny ghost s with one of my graphics. The tools will tell you every element on the page.