You can find the kit here: www.thevoiceofmusic.com/catal...
Жүктеу.....
Пікірлер: 11
@genehammond72394 ай бұрын
Nice tutorial Steve the stylus is always a big concern when what to replac it with !!!👍👍
@waynebrettzky994 ай бұрын
Mister Magnavox
@larryshaver3568Ай бұрын
i have an Arista clone for a Varco tn-02 that i'll put on one of my Magnavox type brackets
@larryshaver35684 ай бұрын
i would put washers under the heads of the screws then the bottom ends of the screws don't stick out so much
@bmccarty20124 ай бұрын
Good idea about tying the grounds together. I installed put a Pfanstiehl from VOM on a Garrard changer in a Packard Bell console, and using all four pins does get very tight. I've been a bit concerned about shorting, so I may use your trick, or slide some shrink tube onto the leads. The amp is also super clean on that unit. Did you polish it up?
@bones007able4 ай бұрын
Last P-226 I got, I broke it immediately... the push pin apparently was not spread apart enough and it pushed the pin right into the cartridge... the p-191 is cheaper and sounds just as good
@SteveScarlet
4 ай бұрын
It's what comes with the kit, never had an issue.....
@bones007able
4 ай бұрын
@@SteveScarletNeither did I until the last time... I also am not a fan of plastic stylus, ever work on a RCA Rp-217 changer?... the needle weight is crazy 6 to 11 grams
@matthewtaylor73554 ай бұрын
Why does vintage regularly sound better than modern
@larryshaver35683 ай бұрын
is there any difference between a p-226 and a p-228?
Пікірлер: 11
Nice tutorial Steve the stylus is always a big concern when what to replac it with !!!👍👍
Mister Magnavox
i have an Arista clone for a Varco tn-02 that i'll put on one of my Magnavox type brackets
i would put washers under the heads of the screws then the bottom ends of the screws don't stick out so much
Good idea about tying the grounds together. I installed put a Pfanstiehl from VOM on a Garrard changer in a Packard Bell console, and using all four pins does get very tight. I've been a bit concerned about shorting, so I may use your trick, or slide some shrink tube onto the leads. The amp is also super clean on that unit. Did you polish it up?
Last P-226 I got, I broke it immediately... the push pin apparently was not spread apart enough and it pushed the pin right into the cartridge... the p-191 is cheaper and sounds just as good
@SteveScarlet
4 ай бұрын
It's what comes with the kit, never had an issue.....
@bones007able
4 ай бұрын
@@SteveScarletNeither did I until the last time... I also am not a fan of plastic stylus, ever work on a RCA Rp-217 changer?... the needle weight is crazy 6 to 11 grams
Why does vintage regularly sound better than modern
is there any difference between a p-226 and a p-228?
those shields do absolutely nothing