Ls s10 nv3500 with spintech mufflers sound clips
5.3 nv3500 swap s10 with hedman 1 3/4” longtubes 3” dual exhaust into X pipe with 2 spintech 6000 mufflers exiting the rear at equal length
Idle clips and ride along
#lsswap #automobile #btr #truck #s10 #spintech #s10life #ss3 #streetcar #dailydriver #dailyvlog #sound #fun #lsswaptheworld #work #life #speed #chevrolet #minitruck #homemade #diy #cruising #lowrider #lm7 #slow #tradition #burble #hptuners
Пікірлер: 14
Sounds really nice man. Do you get any popping when you down shift and let off?
@Ls_swap211
11 күн бұрын
@@MrGsxr10001 I have it tuned in to pop and bang a good bit
Awesome videos!! What flywheel, clutch, and slave cylinder did you use for nv3500??
@Ls_swap211
2 ай бұрын
Flywheel is from a 6.0 Silverado but everything else is from a 99-04 4.8 5spd Silverado Luk brand clutch and slave but the flywheel was a sachs brand I would imagine that everything from a 4.8 5spd truck would fit since 4.8/5.3 share the same block
I just got a 97 s10 2.2 5speed truck. I will be working on very soon. What all do I need for a swap, ls 5.3 stock, get the computer and I want the dash to work.
@Ls_swap211
Ай бұрын
Get the harness if you use the 4l60 trans with it I got a wiring schematic for 96 s10 and I’m sure it’s close enough that I can tell you what wires go to what gauges On mine I had to run 2 separate cooling temp sensors because the ls ecu needs 1 and the other goes to the s10 dash but oil psi goes to dash wire and volts gauge reads from the stock s10 positive power bank on driver side fender , fuel gage is left alone if you run stock tank
Bad ass truck 😎
@Ls_swap211
Ай бұрын
Thanks
I've been meaning to ask you what gear ratio you running in the rear end
3.73 Went 4.10 once but it was too low for highway use
@lumpyswoodworks
2 ай бұрын
What rpm you running at 55
@Ls_swap211
2 ай бұрын
@@lumpyswoodworks I know at 70 I’m at 2800 so around 2000 55mph
What kinda wheels are those?
@Ls_swap211
2 ай бұрын
Old 90s eagle tribals