Hello, can you tell me why do I have to sometimes press 2 or rather 3 time the foot pedal to make a bend, first time I press it the laser shoots and than it stops while im pressing and holding the pedal with my foot and then when I let it go and press it again it goes and makes a bend. Is this some software problem I mean in a touch control panel where I can manage that, or is it some technical problem or psysical. I would really like to know it thanks!
@nicholasvachon42442 жыл бұрын
Production plan: calls-up a different program than what I setup. I cannot find information about setting up production plan in manual for machine. Will play around with it a bit today. Do you know why?
@anthonyyoung244 жыл бұрын
is Boost/Techzone bend required for offline programming, can the machine be programmed with TruTops Bend?
@facepalm0153 жыл бұрын
We just got a 7050 and 5085. Is it possible to transfer bending programs between the two? If so, what are the steps?
@TRUMPFInc
3 жыл бұрын
If they are both TouchPoint controls the programs will transfer but the technical differences between the machines need to be addressed. For the steps, contact the applications dept.
Пікірлер: 8
Hello, can you tell me why do I have to sometimes press 2 or rather 3 time the foot pedal to make a bend, first time I press it the laser shoots and than it stops while im pressing and holding the pedal with my foot and then when I let it go and press it again it goes and makes a bend. Is this some software problem I mean in a touch control panel where I can manage that, or is it some technical problem or psysical. I would really like to know it thanks!
Production plan: calls-up a different program than what I setup. I cannot find information about setting up production plan in manual for machine. Will play around with it a bit today. Do you know why?
is Boost/Techzone bend required for offline programming, can the machine be programmed with TruTops Bend?
We just got a 7050 and 5085. Is it possible to transfer bending programs between the two? If so, what are the steps?
@TRUMPFInc
3 жыл бұрын
If they are both TouchPoint controls the programs will transfer but the technical differences between the machines need to be addressed. For the steps, contact the applications dept.
@facepalm015
3 жыл бұрын
@@TRUMPFInc Thank you. Will do.
@TheChhis
2 жыл бұрын
Hoe much did you pay for the 7050?