My family and I are in the process of purchasing an RV. I just came across one of your videos because I had a question that I needed answering and I came across one of your videos. I just want to say it was very detailed. Well done. I’m sure I will be back to watch more videos. Thank you for doing what you’re doing. It’s very helpful.

Thanks for the help!! Your videos have helped me get out of a few jams, much appreciated!!

Great video Darren I also use the power lube on my scissor jacks works great thanks 😊

enjoy ur videos informative

Just wanted to pass on a great kudo for your recommendation of using the silicon lubricant spray. We have a 2021 Winnebago Voyage travel trailer in Wisconsin northwoods and could not get the shwintek slide out to work. It would only move maybe 2 inches and then motor quits. After lubricating the recommended places from your video voila! the slide out works! It moves in and out smoothly. I keep the buttom pushed for a few seconds after it stops moving so as to complete alignment. Thanks for the great tip!

Thank you for the info. Question: who accessible is that screw to check and tighten?

I have a schwintek slide on a grand design and the black screws on the bottom of the outside trim have popped. The slide also is not closing all the way at the bottom

Just purchased our 1st new to us tt. Hadnt noticed til we got home that the schwintek slide isnt flush to outside wall. The slide seems to go in/out fine but its not flush..is that normal? We are concerned about weather issue and it catching wind when driving down the road. Have subscribed to your channel bcuz i know we need as much help as we can get..Thank you so much from us newbies.

Darren (and anyone else) - I too have made the mistake of using WD40 on my rack and pinion slide out. You mention a degreaser - what kind? I'd like to get it completely clean and use the CRC-PTFE. Simple green and a brush? I was considering the Simple Green - BBQ as it has "degreaser" on the can.

Hey Darren merry Christmas, my hwh hydraulic retractable stopped working local Rv replaced my valve. And it worked for a while then stopped again motor runs but acting like no fluid then will catch and come in any ideas? 2004 coach house 272xl

Love the information here.. coming in late to the discussion about the Slide-In motor. Curious how to access that motor.. just to see if my screws are there? I feel like I should be doing some maintenance on my slide-out as it seems to be making a little more noise this season and I'm not sure where to look to find that motor. Any advice is greatly appreciated!

@MyRVWorks

Жыл бұрын

Hi thanks for watching, if you check out our playlist on Slide rooms, you'll learn more than you ever want to know about these systems LOL. Unfortunately, no two manufacturers put these together exactly the same. The screw that holds a motor down will be on the outside and you might need to pull back a bit of the bulb seal to see it. And some of our videos we do cover where that screw should be located.

PS: I have an electic slide (I think?) 2018 Starcraft Launch.

Instead of drilling and tapping couldn't you use a 1/4 inch 1/2 inch long steel pop rivet. It could still be removed if necessary. Just a thought.

I have an AquaHot 450D with reporter 2.0 in my 2020 Class A. Lately, I’ve been having an issue with frequent Overheat faults. The unit does not overheat immediately on startup, the overheat fault tends to occur after it has been on about 12 hours or longer. It works perfectly until then. It was still in warranty when the problem began, so AquaHot sent me a new Reporter 2.0 which I installed but the issue persisted. Next they sent a temp sensor to change out, but I can’t find any component inside that looks like what they sent. Can you think of any other component that could cause this overheat fault?

@HarmanSingh-fi7bo

2 жыл бұрын

Hi

Concerning the screw - how do you access it? - is it accessible from the outside of the RV when the slide is extended?

@markveerman3732

Жыл бұрын

I was wondering the same thing. Will take a look when I go to the trailer next time and see what location works best.

I tried to access that web site and got a message can not connect to server at this site.

@MyRVWorks

Жыл бұрын

Which website are you having trouble with?

Pex question 2018 pex lol I worked for Boeing also My question is How to heat safely pex in a travel trailer to remove plastic fitted fittings upgrade to brass fittings . Confined space ares 2018 hartland northtrail 23rbs.

@stephenwinters6897

2 жыл бұрын

Debbie said it's 92 degrees out here in FL. You look so warm in that shirt. Lol.

@Yukonjackman1

2 жыл бұрын

@@stephenwinters6897 sun city Arizona 112 right now