I can't believe you only have 63 subscribers

I was installing a faucet yesterday and I looked in amazement of what I had. 😳

Pretty good

Cool

I've used old attachments from vaccumes too.

Great fabrication my friend!

How would you attach a way to carry it around on a belt? I know you can use a cover tech wheel or a d ring but I’m not sure how you would go about installing either of those onto this hilt

@FourPeaksCreations

4 жыл бұрын

A flashlight belt clip would probably be best to keep the hilt from bouncing against your leg. You could also replace one of the washers at 5:40 with a D-ring picture hanger.

@izzyb5729

4 жыл бұрын

Four Peaks Creations Thank you!! I’ll see what I can do!

@Four Peaks Creations can you do one on how to make a fall saber hilt. a fall saber is a double bladed light saber

@FourPeaksCreations

Жыл бұрын

Sounds interesting, I'll look into it.

Is this hollow enough to house electronics?

@FourPeaksCreations

2 ай бұрын

I'm not sure. Some of the smaller boards look like they might fit.

When you measured the length at 3:14 , how long was it? And how long was the entire thing after you were done?

@FourPeaksCreations

4 жыл бұрын

I cut about 5" off of the 12" tube, so the total length of the finished hilt is a little over 11".

Where can I find the aluminum tubing?

@FourPeaksCreations

4 жыл бұрын

A hardware store with a plumbing section would likely have the tubing. I found mine at Lowe's on the shelf right next to where I found the drain.

@ReaIiPlayBedwars

4 жыл бұрын

Four Peaks Creations thanks!!

@fish3r587

4 жыл бұрын

Lowe’s

@fish3r587

4 жыл бұрын

Oh wait, you already said that🤣

hey do you think that you can attach a blade to this if you can pls tell me

@FourPeaksCreations

2 жыл бұрын

You can, similar to the way Punished Props does it here: kzread.info/dash/bejne/c6JnqbyJgqeclNI.html

What kind of rotary tool were you using?

@FourPeaksCreations

4 жыл бұрын

This one www.harborfreight.com/flexible-shaft-grinder-and-carver-40432.html?_br_psugg_q=rotary+tool it's inexpensive and works fairly well

Slow down

Some narration would be good....it really detracts from all that work you did. By the end of the video I was no longer interested in the final product.

Cool