Land Rover Series 3 Restoration Part 9 - Brakes, pipes and clutch
Автокөліктер мен көлік құралдары
Enable captions for comments in the video.
Time to get them brakes and clutch working.
The goal for now is to do a test drive, so I will be putting some stuff together now, that I will be taking off again in a near future when time comes for a paintjob.
After some searching around, I decided to scrap the PDWA as it was rusty, and I kinda broke it, and instead getting a sensor in the cap (not in video)
If you just joined, then what you see in the video is a Land Rover 109" from 1975 that I'm currently restoring to somewhat decent condition.
Follow for more updates as i progress with this project.
Next time, either brakes or pedals. Maybe both :)
0:00 Rear drum brakes
03:31 Front drum brakes
06:01 Rear brake pipes
08:27 Front brake pipes
10:48 Brake pedal housing
13:57 Clutch housing
17:30 Clutch pipes
18:44 Fluid and bleed
19:17 Done
19:49 Testing !
** I may need to mention, I'm no mechanic, so anything you see in this video, may not be the correct way to do this. This is meant as a timelapse/build vlog instead of as a repair guide :) **
Пікірлер: 15
Hello, NEVER use grease in a break! Safe greetings ✌🏼
@CMFotoPeak
Жыл бұрын
Hi, Thanks for being observant. I had nothing else at the time to help the brake shooes get in place. I have replaced it :)
I had *exactly* the same thought about those rubber pads for the pedals when I fitted mine. 1 hour of swearing later.... 🤣
@CMFotoPeak
8 ай бұрын
Oh yes, those rubber pads was quite difficult to deal with :D
Nice!
It is a good idea to fit the brakelines first, the the cylinders. Can you tell the threads and shape (E or F) of the connectors, pls.
@CMFotoPeak
6 ай бұрын
Noted about the cylinders as it was a pain to install. Not sure which connectors you're referring too ?
@HeinerStorchennest1
6 ай бұрын
@@CMFotoPeak I mean the Brakeline nipples. The latest threads are M10x1mm. Some are 3/16"?
Wish I could get all parts to recondition a series 3 88
What brand is the brakelight switch,pls.? I tested several ones, as a lot of them don't last longer than 2 or 5 stopps.
@CMFotoPeak
6 ай бұрын
I think it's the original, as i didn't change it. it says 39184 and 1381A on it. I haven't actually tested if it works yet ;D
what is the tool you made the brake line ends with called and where did you get it?
@CMFotoPeak
Жыл бұрын
Try searching for Brake Flare tool kit. Every car part place should have it.
Traduire en Francais.Mercie