KTS - Default Bolts (joints.def) in Tekla Structures

This video shows how to use the joints.def file in Tekla to control the default bolt diameter and number of bolts on shear tab, clip angle, and end plate connections. You can use the AISC minimum or maximum rows of bolts as a starting point.
Chapters
00:00 - Introduction
01:01 - Locate the joints.def file
02:35 - joints.def file contents
05:32 - Copy joints.def to the model folder
06:35 - Explain max rows of bolts
07:54 - Modify existing connections
09:52 - Overriding joints.def

Пікірлер: 5

  • @dawid-dyrcz-ddbim-eng
    @dawid-dyrcz-ddbim-eng7 ай бұрын

    I thought I knew everything about Tekla Structures... and, surprise, "joints.def" 😆

  • @KeyackTechnologySolutions

    @KeyackTechnologySolutions

    7 ай бұрын

    I have been using Tekla since 2005, and there's still a ton I don't know. :)

  • @MegaBirdView
    @MegaBirdView7 ай бұрын

    although I've been using the software since the "XSteel" days! I always take a deep breath before Clicking on any of your videos.

  • @KeyackTechnologySolutions

    @KeyackTechnologySolutions

    7 ай бұрын

    :) Is that good or bad? :)

  • @MegaBirdView

    @MegaBirdView

    7 ай бұрын

    @@KeyackTechnologySolutions Definitely good, i always learn new tricks watching your videos although I consider myself a "Tekla Expert" but your videos tell me i have a long way to go before calling myself an "Expert" :)