Great video. Just about to replace my friction plates. So a great help. Pleasantly surprised how cheap the ktm parts are.

@RhoadsChristopher

Жыл бұрын

Yup, pricing isn't too bad. I have another video where I talk about laying the bike down on its side so you don't have to dump oil. If you run into any problems feel free to reach out.

Very good

@RhoadsChristopher

Жыл бұрын

Cheers

How different does the clutch feel? I have the full EBC SRK clutch kit for my ‘16 390 and I have yet to install it. It came with Kevlar clutch plates, the heavy duty springs, and some new steel plates as well. Think I should have gone stock OEM for the plates? I have some slippage in high gears so I figured it was time.

@RhoadsChristopher

2 жыл бұрын

No noticeable changes as of yet. However, my clutch plates looked great! I'm running stock oem plates with no issues.

Looked like you are doing the reverse way.. the conical should be facing the bike and the cup portion should be facing towards you. That is in the manual. Can you reconfirm.Thanks

@RhoadsChristopher

2 жыл бұрын

Let me look into it

good job ! keep going bruv

@RhoadsChristopher

9 ай бұрын

Thank you!

the conical shape should be facing towards the engine

@RhoadsChristopher

2 ай бұрын

Yeah I fixed that. Turns out it'll drive just find thr other way still.

Did you remove the clutch earlier? The cone shape of the judder spring, must go inside, not outside? You sure about that?

@RhoadsChristopher

Жыл бұрын

I got one of them mixed it. I have corrected it. It'd talked about in the comments. Interestingly enough, you can drive around with no problems if you get this mixed up haha

What does the shift kit do or help with?

@RhoadsChristopher

2 жыл бұрын

The clutch springs?

Please share part number of clutch plates

@RhoadsChristopher

9 ай бұрын

I'm heading into work, but I can shoot you that info

@RhoadsChristopher

9 ай бұрын

What year is yours? This is the parts kit number 90232111010

What year?

@RhoadsChristopher

2 жыл бұрын

2016,but should be the same for 2nd Gen

The one last disc you install it wrong 😑

@RhoadsChristopher

2 жыл бұрын

Yup I noticed it. Big oof on my part. This is been corrected. One thing to note, it didn't seem to matter as my bike had zero issues driving like that.

@KimlongChan95

2 жыл бұрын

@@RhoadsChristopher performance is not different. The difference is that one last disc need to be offset by one tooth to counter the force of the other 6 disc so the main shaft will not bent and it will prolong the life of your main shaft.