Thank you for the video. Very nice job. Now I feel confident, will be doing this job very soon.

@ALI_FIX12

9 күн бұрын

You welcome sir ... you can do it ... thank you for watching 🔧❤️👍🏻

If you have the time, you can freeze your bearing and also if needed heat the arm and eliminate the need for a press. You can also make one pretty quick with some wood, some structural screws and a jack, for the ones without a pro press and lots of time to waste lol

@ALI_FIX12

2 ай бұрын

thank you sir for note 👍🏼 you professional 🔧🔧🔧

Best channel on youtube 👍

@ALI_FIX12

7 ай бұрын

you welcome sir ... thank you for watching ... do not forget to subscribe to my channel ❤️🔧👍🏻

Had to be a press involved... thanks. Not what I was hoping but now I know I need to take it to a shop before taking it apart to see if I need to just take it to a shop.

@ALI_FIX12

10 ай бұрын

you welcom sir ... thank you for watching 👍🏻🔧❤️

@Igor_ZG

6 ай бұрын

I wanted to know that too... Very nice video Sir! 👍

@rootsAlkebu

5 ай бұрын

😂

@MrKevinc33

4 ай бұрын

Just take the hub to the shop and have them press it. Save hundreds don't be lazy

Does car need a four wheel alignment after this repair? Or should i do markings on shock absorber to get it on same position? (Those 2 bolts on upper part)

@ALI_FIX12

9 ай бұрын

you dont need wheel alignment after this ... it does not affect ... you welcome ... thank you for watching ... do not forget to subscribe to my channel ❤️🔧👍🏻

You never showed how you removed the circlip before pressing out bearing race. The one I have is recessed all the way so I can't get snap ring pliers on it. How did you do it?

@ALI_FIX12

Ай бұрын

Do it with a screwdriver click from below 🔧👍🏼 sorry Sorry sir because i didnt show that 😔

Im trying to do this process myself. But it seems like the axle nut was dented into the notch and is impossible to turn, any reccomendation to try to undent it?

@ALI_FIX12

5 ай бұрын

sorry about that 😔..you need molds when working on press ... you can change new piece ... try that agin you can do it 👍🏻🔧

What year was the forte and do you have a li k for the bearing? Thank you!!

@ALI_FIX12

Жыл бұрын

I think 2013 ...sorry I do not remember good ... You welcome 🤗😊

ماشاءالله الله انا عايش ب امريكا عندي نفس المشكله يريدون من عندي تصليح 270$

@ALI_FIX12

Жыл бұрын

الله يحفظك و يبارك بيك .... احنه نشتغل بالعراق ... هذا الشغل فقط ب 30 دولار تقريبا

Why did i just perform this same process but the new bearing wobbles like all holy goddamn FFUCK still after putting the new one in??

@ALI_FIX12

5 ай бұрын

You must press well or maybe Steering knuckle Wide and damaged ... good luck sir