This saved me TONS OF TROUBLESHOOTING!!! Thanks for posting!!!

That you for the information I’m buying the relay. I jumped it out with a cotter pin for now because the laundry needs to get done.

Relay fixed mine thanks

Any one know what's the part number for bucket Belt for thr same Dryer !! I have thr same one and it snapped !!

Having this issue but isn’t belt

Thanks

Ive replace 3 thermal limiters and then i replaced all 4 electric parts on backside of dryer like thermostats etc. It was working on trial. Now the next day wont start. I notice a smell from heating element but only ran it on medium heat for a few minutes. Seemed fine now next day wont work again. Any ideas?

@snoopfurlow1275

7 ай бұрын

Check your start switch,heating element,clean the vent

I want to disconnect the start switch button, not to use drayer. Can i just disçonñect the wires of switch button??? Or any other way. I have kenmore old dryer.

@user-hc9lp3hb1r

5 ай бұрын

Not sure what you are asking? You don't want anyone to turn the dryer on? Why not just unplug it? Disconnecting the switch wires (and covering them with insulating tape) will also work but it seems like more work than necessary.

there 2 relay switches? should i change both?

@ponyotran2996

2 жыл бұрын

Since the dry is old, i think is better to replace both. Because the other one would go bad soon.

Hello .l have the same problem so I change both relay and now it starts but will not stay on . what can it be can you help , your my only hope ob1

@ponyotran2996

2 жыл бұрын

Do it stay on running if you hold the door press in? If so than could be the door switch is bad

@FACB25

2 жыл бұрын

@@ponyotran2996 hey I was looking around the board and found a wire loose and connected it back to the time and now it stay on after I press the start button . Thx for replying quickly

@ponyotran2996

2 жыл бұрын

@@FACB25 good to hear is fix.

I replaced the start switch and relays and still won’t stay running

@ponyotran2996

Жыл бұрын

Check your door switch?

@user-hc9lp3hb1r

5 ай бұрын

Could also be the moisture sensor or overheat sensors.

Did yhis fox it ?

@ponyotran2996

3 жыл бұрын

Yes it did fix it.