Unscrew the 6 hex screws on the side of the Tb and just turn the wheel about a 1/4 of a turn and it will make your cable more tight but out lock tight on the screws when you put it back on

Good videos here. Subscribed man. Keep it up.

Hey super appreciate your videos, had an idle position sensor question on your old JDM engine swap video?? Hoping to hear back how you solved that idle bounce issue. Thanks

Like your videos Serg. Can you do an oil catch can video sometime?

you could also make your own rad hose by splicing two together if you cant find what you need

How do I fix my rev hang on my skunk2 tb, when I let off it stays at 2k rpms then if I tap the gas it drops to normal at 1k

Hall effect sensor - magnetic rather than having contact points that can wear out. Albert Marty suggested I use one on my build so i hope it works as it's supposed to. Using B series sensors and an adaptor is supposed to work well too.

What size silicone coupler fits on that TB?

What’s the best way to contact you? I have a question about an Acura RSX clutch replacement.

Friend, a question, I have the ultra Race skunk2 manifold but it does not fit in my k24 because where the vanda goes it hinders me, I have to do

Does the 80 mm ktuned tb fit the skunk 2 manifold

What's the part number for that throttle body

is this the domestic style?

Wait what...their K tuned throttle cable doesn't fit properly in their K tuned throttle body? Yikes...I know this vid is 3yrs old but I hope this issue has been resolved...

@pacific7775

Жыл бұрын

It fits perfectly , you adjust the wheel a partial turn and itl be tight

#SERGMOTIVE

I think you should clean or paint your valve cover, just saying

@SERGMOTIVEGARAGE

4 жыл бұрын

thats just a spare cover i have on lol I have a freshly powder coated one ready to go on when im done

@Honda_Motorsports92

2 жыл бұрын

SERGMOTIVE GARAGE Can you fit this to a stock RBC manifold? Or do I have to buy a aftermarket Intake manifold (which I don’t want to do)

Yo my k20a2 makes a rattle once it starts. It can be heard still when reving around 2k and 3k rpm.Can it be vtc actuator? It's not a rod etc

@SERGMOTIVEGARAGE

4 жыл бұрын

could be vtc or chain slap

@kudzy11

4 жыл бұрын

Does it stop once up to temp? Just read this on k20a.org, sounded similar : www.k20a.org/threads/stock-k20a2-rattle-in-head.93231/ VTC actuator.

@raton5936

4 жыл бұрын

@@kudzy11 sorry for the late replys peeps. Yeah it still does the sound and it can't be the chain slapping as I added a new chain and tensioner. I'll check out vtc

@supers0nic77

2 жыл бұрын

In for the update