Fantastic installation. Easy to see as well. No cutting involve on the frame. I wanted to avoid this and you just bend the metals bits and cover it with plasitc. Definiately buying this kits for my Chaser jzx100. Thank you for uploading and sharing. :)

PERFECT AS ALWAYS!!!greetings from Poland:)

Your video is so relaxing. Subbed!

Hey man, I jus want to say keep up the good work man. You really taught me a lot on workin with 1jz motors 🙏

Awesome video. Great insight for my Mark II, hoping to see more!

@muridori7928

Жыл бұрын

Thank you! Your kind words sure do encourage me to do more :)

I love these videos please keep it up!

Nice! Also another idea, instead of using plastic as protector for the piping, just use rubber edge trim! You can double side tape the inside and then stick it. It’ll never come off! There’s also door edge guard trim that already have 3m tape on them for cheap. Nice and clean work though 👌

@muridori7928

Жыл бұрын

Thanks for the tip, I'll definitely use that next time!

Dude, good videos. Where are you, or this car? updates? upgrades? be nice to follow. I like your simple video approach.

Presentation was very top notch quality and want more informative content like this thank you

@muridori7928

Жыл бұрын

Thank you so much!

@ibrahimjubayer8373

Жыл бұрын

@@muridori7928 most welcome

I’m surprised you didn’t have to trim the bumper. I’ve seen a lot of guys having to trim theirs for the intercooler to fit. Job well done!

@muridori7928

Жыл бұрын

Thank you! I found out afterwards also when searching for other IC installation videos on youtube that everyone seems to be cutting their bumper and even the frame. There was plenty of clearance so I did nothing to the bumper, should have filmed it too. The Blitz instructions say that make sure that the front bumper does not interfere with the ic or the piping. So my how I see it is that cutting might not be necessary. The BLITZ SE kit can be installed on all 3 models of JZX90 and JZX100, MT or AT models too so it might vary a bit on other variants than mine.

@brandonnickerson3077

Жыл бұрын

Good to know! I should be receiving my chaser this month so I’m excited to wrench on it.

Wow just amazing

More videos!!! Love it.

Man very detailed and very well shot vid. Kinda like the ASMR lmao

Saving this for later

Nice video brotha. I'm about to install a Koyo Radiator myself because mine is turning yellow.

Продолжай в том же духе, очень приятно смотреть!

Moreee videos please🙏🏻

Do you possibly know of an over the counter cleaner that will clean the water spots typically found on JDM imported cars?

Niice

The blitz charge pipe 2.75"/70mm?

Who did your headlights with projectors?,

where did you buy the blitz IC?

What a great video. If you don't mind me asking where did you get your water pump kit on your last video ?

@muridori7928

Жыл бұрын

I bought it from a parts store in Japan, but if you need oem parts to be shipped overseas I highly recommend Amayama.

How long did u leave the car running to bleed it

@muridori7928

Жыл бұрын

Maybe less than 15 minutes? I heated it up until the thermostat opened and let it circulate the air out by revving the engine. Also coolant level checks after short drives was done to make sure that there was no air in the system any more.