I'm on my daughter's KZread account. I've found out that every time I have a surging problem is because the idle circuit/jet is plugged. Never the main jet. A plugged main jet will keep it from running. A plugged idle circuit/jet doesn't let gas through resulting the governor opening the throttle more until the main jet feeds the engine, which is too much and the governor slows it back down. The idle circuit/jet is plugged so it slows the engine too much so the governor opens the throttle more. It keeps going back and forth. (Surging) I've had main jets partially plugged but it never caused surging. Just under powered or loss of speed.

Before taking the Carburetor off and apart try this little trick. Change the Fuel Filter as in this Video. Fill the gas tank to half way. Put Two Teaspoons of Gas Treatment “STP or SeaFoam,” per Tank Capacity, “Gallons.” Fill the tank up. Go ahead a mow the grass, with intermittent Idling. Most likely the problem will clear up before you get to half a tank. On smaller Engines with unknown capacity, add the Fuel Treatment to the Gas Can. The Gas Treatment Measure doesn’t have to be super accurate, just don’t dump a bunch in the gas tank. This has worked on 6.5 and 11 Briggs Engines, 18 HP Kohler and Kawasaki. Unknown Engine on Chipper, Power Washer and Snow Blower. Even fixed a Chainsaw after Cleaning the Fuel Strainer in the Fuel tank, and with a new Spark Plug.

Great video! Helped me fix the surging Kohler Command 23 on my JD L130.

Thank you for posting.

THANK YOU FOR YPUR HELP

Oh man I love the smell of fresh cut grass in the morning nice job cleaning out that carb !!

@stevenmoomey2115

2 жыл бұрын

If you are held back by wet grass with the Morning Dew on it. Do this, take a piece of 3/4” to 1-1/2” pipe, length sized to your yard. Drill a hole in each end. Thread heavy twine or light cord through the holes, making a large loop with the cord. Drag the pipe across the lawn. This will knock the dew off of the grass, and the grass will quickly dry.

Working on a GT5000 with a similar Nikki and my local parts house wants $68+Tax for a rebuild kit. Likely go with a cheap Amazon carb replacement for $32 or so since it’s 20 years old.

Sounds good,in my experience most starting and running issues are related to just what you did to this carburetor.

Hey Hank, thanks for the video, it was very helpful. I do wish you would have shown how you got the retainer clip off the linkage. Lol I lost mine.

I like using the same fuel filters with with a metal screen instead of the paper filter. You can blow them out with compressed air with good results.

Looks similar to the KT7500 engine in my Husqvarna and the worst engine I've ever owned. I noticed the engine stick when you turned it over - mine sometimes takes a number of tries before the starter turns the engine. It's had intermittent problems that I noticed before 30 hours but it was a late season purchase and may have always been a lemon. Sometimes it runs fine when cold and then hunts when it warms up and other times it hunts when cold and improves when it warms up. It's been tuned and tested but I haven't pulled the carb. Thanks for the video, I expect mine will be similar and probably need to pull it to troubleshoot.

Changed my gas filter and spark plug after 10 years on my John Deere , which has been two years ago . I got too looking I could see a little debris in the gas tank , don't care how careful you are your going to get a little debris in one .

Do you have a rebuild kit number for this carb or any info

Help me a lot THANK YOU

Nice video. I have the same mower and same carburetor (Keihin). Do you have any idea what the top of the carburetor under the plate does? ( the part with the little maze). I was going to open it but one of the screws is stripped. Can't get it open.

@hanksgarage_

7 ай бұрын

You don’t need to worry about that. I believe it has something to do with the mixture ratio or air metering. Small engine carbs will always clog in the bowl and pick up jets. Those passages up top never touch fuel.

@jimstelljes3925

7 ай бұрын

OK. Thanks for your response. I cleaned everything else.@@hanksgarage_

AWESOME VIDEO!!! THANK YOU! what can you do next after you clean the carburetor and it still keeps surging? thanks again.

@hanksgarage_

Жыл бұрын

You may have an air leak. Check the condition of the gaskets for the carburetor. Did you change the filter?

@jimmyfinke6759

Жыл бұрын

@@hanksgarage_ yes sir i did, new sparkplugs, new fuel filter, new carburetor, it's the strangest thing i have ever encountered , i adjusted the governor and check the springs, check the carb linkage..

@BenWatson2

Жыл бұрын

@@jimmyfinke6759I’m having the same exact problem. Replaced carb, air filter, and fuel filter. And still surging.

@mizaelnoriega9301

2 ай бұрын

@@BenWatson2did u fix it? If so how?

@BenWatson2

2 ай бұрын

@@mizaelnoriega9301 no, never got it fixed. Ended up selling it.

I bought craftsman kholer used and ised it till later summer, parked and wouldn't start, took air cover off and there was no air filter hard to know how long its been off before me, I cleaned carburetor, changed plugs and fuel pump. What else would need cleaned out from having no air filter on for extended time thank you for feed back

@hanksgarage_

Ай бұрын

Nothing really else to clean off. Just hope the rings aren’t worn out

Mine was surging I just sprayed carb cleaner in it running full throttle and sprayed 5 or 6 times and didn't have to take it apart runs fine

I’ve replaced the: Carb (with an OEM kohler) Fuel pump Fuel filter Spark plugs ( I have a kohler v-twin pro series 7000 engine) Air filter Battery Blades Oil and oil filter And the damn thing STILL SURGES! I have run out of ideas. Any tips would be great, thanks!

@hanksgarage_

2 ай бұрын

You may have an air leak at the carburetor gaskets or somewhere else messing with the mixture. How old is the gas?