Great job on prioritizing the order of these Telemetry Videos ! I say that because I wanted to know how to display and log my Receiver Voltage and now I can go flying tomorrow for the first time with this radio and do that.

Harry I need to do a left rudder to right aileron knife edge mix. Would appreciate your input.

@cotswoldpilot

3 жыл бұрын

kzread.info/dash/bejne/dXycpqirmqS0f9o.html

Hello Harry, I have a question about the capabilities of Telemetry: Is it possible in a Telemetry Log, to see what amount of Elevator Trim was added mid way through a flight IF that trim was later removed again before landing? I ask this question because I have a Corsair with Rotating retracts that move a lot of weight to the rear of the CG, so the trim for flying with the Gear Up is going to be different than the trim with the Gear Down. So, if while I'm flying I raise the landing gear and add the Elevator Trim I need for that configuration, and then lower the gear (to land) and re-adjust my trim for the Gear Down Configuration, is it possible to go into the Telemetry Flight Log after I land to see what amount of Elevator Trim I added while I had the gear retracted? That way I can add a mixing mode switch and know how much Down Elevator to mix in when I'm flying with the landing gear retracted. Thanks again for your help with my questions.

@cotswoldpilot

3 ай бұрын

Sensors/logging, transmitter status info

@michaeldamico5152

3 ай бұрын

@@cotswoldpilot Thank you for your reply. Can you tell me if if I would need to purchase any additional modules / options for my Basic DS12 Transmitter in order to see the Sensors/logging/Transmitter Status data?