JCB 3CX BEARING TRUNNION 2
Автокөліктер мен көлік құралдары
jcb 3cx bearing trunnion,jcb 3cx bearing,jcb 3cx trunnion,jcb 3cx,spider cap,jcb 3cx,bearing taper roller,joint knuckle swivel ram,jcb 3cx csapágy,jcb 3cx féltengő,jcb 3cx kardán ,kerékagy, kardánkereszt,seal,
Пікірлер: 34
I miei complimenti per il lavoro di riparazione del fusello che hai eseguito alla terna , 💪👍👍👍Bravo
Lovely machine!
Jcb 3cx Top 👍
Ай, молодца!👍👏
Bravo top
Excelente Job, painted and all, 👍
Úgy tűnik, tiszta vagy és rendezett. Soha nem veszítesz, ha szervezett vagy. Nagyon jó munka haver.
Good job 👍👍
✌️👍
always give the ol UJs a clout with hammer to make come lose a bit ,therell always be a bit stif when 1st put together , fill the cups with grease to stop the needles falling out , if one doesnt have a press ,the vice does the same job , good video of doing the trunions , well done , ol chap
Hello bro I am jcb service engineer from India
🤝🤝🤝🤝👍👍👍👍👍👍💪💪💪💪🔥🔥🔥🔥
You need to heat bearing up to fit
To do this job you really have to keep your bearing.
Probably should've packed those bearings with grease before installing
@quotesfor_u_99
Жыл бұрын
Yes
Jó napot Laci először is Boldog újévet kívávok. Nagyon precíz fasza videó. Szeretnék tőled valamit kérdezni, hogy mi lehet a gond JB 4cx a hátsó gém rögzitésnél a kapcsolóval a rögzitőkről a nyomást akkor azt könnyen át lehetne tolni a gémet egyik oldalról a másikra.Előre is köszönöm
Good morning
Wrong grease nipples in driveshaft crosses,they should be on the corners .Driveshaft cannot be greased.Good video otherwise.
Номера подшипника какие?
Let me know if you want a Job here in Australia
How many hours did the old bearings and seals do
@lacibatoch1673
3 жыл бұрын
I don't know. That's how I bought it.
@mordekai4182
3 жыл бұрын
@@lacibatoch1673 thats a lot of work to do and change it. How much money were the parts only?
It looks too new to go bad already. Previous owner must have never used a grease gun on it. There was still paint on the zert.
@disturbedcarrot
2 жыл бұрын
I think it was painted
Link to bearing race tool?
jcb 3dx mujecahe 400000
Use
only from hindi ok
Hungarian - right ?
@disturbedcarrot
2 жыл бұрын
Well done for recognizing that, my wife is Hungarian (Pécs) and I'm around the language all the time but still found it hard to identify it.
Sei masterchef.mecanic