This looks like the perfect bumper to go with my new winch on my 23 Gladiator that came with the crap plastic front bumper. Nice video. Thanks for sharing.

Bumper arrives Friday! Just the vid I needed. Good job, Hiram.

You did good, my man. Nice, clear, fun tutorial!

@itsadadlife

5 ай бұрын

Thank You !!

Love the look of this setup. When I'm ready to swap out the factory bumper, I also plan to do a winch and bull bar. Looks clean. Are you going to put anything below it like a skid plate or shield to hide those lower bolt holes and protect the front end any? Just curious. I thought about grabbing an OEM steel bumper with bull bar and steel skid plate below. Undecided but I like yours alot. oh, and to answer your comment in the video.... I have a Rubicon and it's plastic front bumper and plastic piece below too. I wish it was steel. Cheers!

@itsadadlife

2 ай бұрын

Yes, I do plan to implement an under skid system, probably from Metalcloak and address that lower section at that time. In the meantime, other than looking a bit silly, it doesn’t hit on anything so it’s not high on my to do list.

I have the same bumper setup. I wish they made a matching rear bumper for the JT.

@itsadadlife

10 ай бұрын

The bumper is great. I will most likely be installing a metalcloak or motobilt rear bumper

Nice video. So there is no more OEM front skid plate after installing the bumper? Did you get a new skid plate?

@itsadadlife

9 ай бұрын

They do sell an aftermarket skid that goes with this bumper. I planned on buying it but I put the factory skid back on for now.

Is that a 1/2 impact gun or 3/8?

@itsadadlife

8 ай бұрын

3/8 DeWalt 20v