Installing Fiber Reinforced Plastic (FRP) to Waterproof Shower Walls
Тәжірибелік нұсқаулар және стиль
Waterproofing the painted wall of a bathtub shower with Fibre Reinforced Plastic stuck to the wall with FRP Liquid Nails.
@00:00:00 Intro + FRP Basics
@00:00:47 Saw Blade + Cutting FRP
@00:01:50 Dry-fit + Corrective Cuts
@00:02:15 Glue Application + Affixing to Wall
@00:03:17 Inside Corner Molding Cut & Glue
@00:04:07 Drilling Shower Hole + Affixing Front & Back Walls
Пікірлер: 19
There is a specific trim molding called a corner bead that should be used on the inside corners to create a water tight seal. It looks like you are using an end cap in the corner.
FRP is a good way to waterproof on a budget
Nice brother! We use this in affordable housing rental showers. Definitely waterproof and worth the 25 bucks a sheet!
@bobtailsthecat
7 ай бұрын
$43 now :/
You have learned a lot son. I'm so proud of you.
Thanks..I'm fixing to do 2 showers top to bottom..this sure helps..
How is it holding up? When I read the adhesive manufacturer’s install sheets it states that one of the surfaces needs to be porous. They do not consider a painted surface nor moisture/mold resistant drywall as porous. They state you need a solvent based frp adhesive.
@ProTechEpoxyFloors
2 ай бұрын
If you have a painted surface just sand it rough
Could you put the glue on the wall rather than the board? Also, could you fit the corner trim on the board before you hang it?
Can you paint FRP? Which paint would be best?
How about using a laminate roller to squeeze out the air bubbles? Can you clean (wipe down ) the backside with Acetone? Or did you just blow off the dust and wipe with a damp cloth? Im looking to build a cargo trailer shower with the FRP
@begincarpentry2184
2 жыл бұрын
As I understand it, acetone would be used for cleanup. A pressure roller might be very effective, but I'd be careful not to transfer any discoloration (if for example the roller is made of rubber) to the FRP. I used a vacuum to both clean and blow off particles, and I wiped down the (existing) wall area with a lightly damp cloth before cutting the material, allowing time for the wall to completely dry. I wish you luck and success on your shower install, let me know how it turns out.
Hi what is the name of the glue
@begincarpentry2184
Жыл бұрын
Titebond Fast Grab FRP Adhesive
As a homosexual man in his 40’s I find this video extremely offensive
@begincarpentry2184
Жыл бұрын
Feel free to elaborate
@bar20bbq70
10 ай бұрын
I find homosexuals offensive.
You are too busy modeling🤦♀️ NEXT.......
@begincarpentry2184
Жыл бұрын
🤣